Gecko's new In.Ye-5 control system with heater. The In.Ye has built in heater probes which provide for self diagnostics, freeze control and verification of water flow - No more Pressure Switch! Also WiFi Ready via In.Touch 2 system (Sold separate). Can setup for various configurations right from the topside control. These settings make the in.ye system work with spas that have a single pump all the way up to dual pumps with circ Pumps. This is truly a versatile system.
Compatible Topsides: In.K450, In.K.200, In.K.35, In.K.19 (Dual and Single Pump Versions)
Features:
- Supports topside, heater, and 5 configurable relays/circuits
- Solid-state water flow detection: No pressure switch to adjust
- IPX5 rated waterproof design
- Preloaded configuration allows fast and easy installation
- in.touch WiFi module compatible (Sold Separately)
- 115v/230v Convertible
- Each output voltage can be configured to 115v or 230v
- Standard 15" 4.0 KW Heater w/ 2" unions, Fixed
Control Box Dimensions:
| Height | Width | Depth |
| 10-3/4" | 19-5/8" | 5" |
Please Note: This pack may require minor adjustments to the voltage selection and the low level setting. These systems come out of the factory set for 220 Volts incoming power (electric line) and 240 Volt pump, blower and ozonator circuits, but can easily be converted to 115 volt. To convert the circuits simply move the white wires under each receptacle from the N box to the L2 box. N = 115/120 Volt and L2 = 220/230 Volts
SCAN THE QR CODE ON THE OUTSIDE ON THE CONTROL BOX FOR TECHNICAL DOCUMENTS THAT MATCH THE REVISION OF YOUR CONTROL SYSTEM.
Follow the illustrations on the circuit board. See below
Check the configuration sheet below for specific receptacle locations. Each setup routes a certain component to a receptacle. This is because this versatile system can be set many ways depending on needed support:
| Manufacturer | Gecko |
| Model | in.ye-5 |
| Supply Voltage | 115v, 230v - 4 Wire |
| Heater Type | Fixed - Bottom - 15" Flange to Flange - 2" Union (3" female thread) |
| Heater Wattage | 1.0kW, 4.0kW |
| Circ Pump Ready | Yes 115v/230v |
| Auxiliary Topside Ready | Yes |
| Fiber Optic | No |
| Accessory Ready | Yes |
| Wi-Fi Compatible | Yes |
| 50/60 HZ | 60Hz |
Here is some information on getting into the Low Level (LL) and Breaker (BR) Settings. The LL setting is set depending on what equipment you need to support:
Here are the Low Level Config Settings for this system. Once you find the configuration you need check under each item for the location of the receptacle - For example, Pump 1 = A2 :
