Skip to main content
This Original Gecko Spa Hot Tub S-Class Heater 4.0kw w/ Pigtails, Pressure Switch and Gasket Has Been Replaced w/ A new model

Gecko Spa Hot Tub S-Class Heater 4.0kw w/ Pigtails, Pressure Switch and Gasket, SSPA How To Video

MSRP: $249.99
$224.97
(You save $25.02 )
(No reviews yet) Write a Review
SKU:
HTP9920-100AAR
UPC:
740016014355
Adding to cart… The item has been added

You are buying a Complete Replacement 4.0KW Heater Assembly that fits a Gecko SSPA or Spa Builders Pack. This Heater Assembly includes the Tube, Element, Pressure Switch, Split nuts, pigtail wires and Gaskets. The new version of this heater includes dettached pigtail wires to connect from the element terminals to the circuit board - everything you need for a clean installation. Your bonding lug will get transferred from your old heater to this new one.

NOTE: If you have the old style SSPA board with the soldered on wires or pigtails like you see in the picture above this heater will still work... simply disregard the included pigtails or click here for that model: Gecko Spa Hot Tub S-Class Heater 4.0kw Soldered Tab Style with Gasket SSPA How To Video

I also offer the element only or pressure switch for this SSPA Pack in our store. Watch the video for more detailed information. NOTE: This listing is for the heater tube, element, Pressure Switch, wiring pigtails and gaskets only any other parts are for illustration only. We have plenty of these.

Housing Configuration Straight
Heater Length 15"
Lead End Terminal Location 5-3/4"
Threaded Tap Orientation 12 O`Clock
Threaded Tap Location 9-7/8" From Leading End
Kilowatts 1.0kW, 4.0kW
voltage 115v, 230v
Sensor Stud Orientation None
Mounting Stud Type Fixed
Heater Size 2"
Heater Application Gecko
 
Watch the video for tips on how to diagnose this part. Normally on this system you will have 3 dots flashing on the topside showing a Flow Code but three dots can also mean a hi limit code if there is a tiny red light lite on the lower right of the board. If it is a hi limit code that means the heater overheated at some point and you cannot clear the three dots with the red light unless you power down and back up. Some of the causes of a hi limit code can be a stuck closed heater relay, a combination of no GFCI Breaker and a hole in the heater element shorting the element to ground and keeping it on, bad board or hi limit sensor.. The causes of 3 dots and no red light which is a Flow Code could be a stopped up filter, pump #1 not operating sometimes or at all, a faulty pressure switch not closing when it has water movement...If all systems are working with no 3 dots code but no heat you would verify incoming voltage, proper voltage to the heater and then test the heater to see if it is open... Thanks, Spa Guy 
sspa,s-spa,gecko,s-class,scales,s class,heater, element, pressure switch,3 dots, flow code, flo code,9920-100338,9920-100339,spa builders, dynasty, nordic,pack,control,plastic, 
!