The MODPACK 101 is a universal replacement spa control system. Heater assembly is 15″ long, it is mounted to the back of the enclosure. To simplify the replacement process, heater tube height is adjustable so it aligns to...

This parts is a Gray Weir Door that fits Waterway slide down front door covers that usually have (2) PWW-50 style 1 1/2" SAE Thick Thread style Filters.. This door measures about 14" wide and 5 1/4" tall and it has pins built in on each bottom side that...

This item is a Replacement Diverter Cap and O-ring Kit for a 1" Waterfall or Neck Jet Control.. The inside thread measurement is about 1 5/8" and the center hole is about 3/4".. It uses (2) Small o-rings and one O-Ring Gasket that measures about 1...

This part is a Starter Capacitor that fits many 115V and 230V Pump Motors. When diagnosing pumps for a no start condition where it is powered up but just hums you can hand spin start the motor by taking a screw driver to the shaft in the back and...

This parts is a Weir door that fits Waterway slide down front door covers that usually have (2) PWW-50 style 1 1/2" SAE Thick Thread style Filters.. This door measures about 14" wide and 5 1/4" tall and it has pins built in on each bottom side that...

This Part is an 48 Frame 2.0HP TMCP Aqua-Flo Wet End for a Garden Tub Bath Pump that has a voltage of 115V and an Amperage of about 16 Amps..  Note: The outside measurement of the threads on this wet end are about 2 3/8" meaning the inside...

This Part is an 48 Frame 1.5HP TMCP Aqua-Flo Wet End for a Garden Tub Bath Pump that has a voltage of 115V and an Amperage of about 14 Amps..  Note: The outside measurement of the threads on this wet end are about 2 3/8" meaning the inside...

This Part is an 48 Frame 1.0HP TMCP Aqua-Flo Wet End for a Garden Tub Bath Pump that has a voltage of 115V and an Amperage of about 12 Amps..  Note: The outside measurement of the threads on this wet end are about 2 3/8" meaning the inside...

This Part is an 48 Frame 3/4HP TMCP Aqua-Flo Wet End for a Garden Tub Bath Pump that has a voltage of 115V and an Amperage of about 10-11 Amps..  Note: The outside measurement of the threads on this wet end are about 2 3/8" meaning the inside...

This item is a Modified 2 1/2" Heater Union Tailpiece with a Pressure Switch Tap and Gasket that is used on may heater tubs that measure about 3" inside diameter of the tube.. It also has a 90 degree 1" Barb fitting.. This Union has had a Pressure Switch...

This part is a 2 1/2" Heater Split Nut with a Gasket which measures 3 9/16" Inside Diameter of the threads and 3" inside the ceneter part that wraps around a heater tube or body. The Heater Flange Split Nut mounts to the heater tube using 2 screws to...

This part is a set of (2) Bearings that fit most motors that are used in hot tubs, this bearing is 17MM ID. Some of the motors this fits are A.O.Smith/Regal Beloit, Century/Regal Beloit, Franklin Electric, General Electric NOTE: Installing bearings...