This Seal Set is used ONLY in Watkins HotSpring Caldera Wet Ends where the motor has the Vendor code of 3536. It is 1 39/64" Across the back of the Spring Seal part that goes into the volute or wetend back and the Ceramic & Rubber part that goes...

This Kit Fits Watkins, Vendor #4081, Wavemaster Pumps found under the name Wavemaster. This Kit Features (2) Bearings, (1) Seal and (1) 1/2oz Tube of The Professor's Silly Juice a Specially Formulated for Hot Tubs Silicon Sealer.   Note: Watkins...

This is a Set of (3) barb plugs used to plug off a 3/8" port on Air manifolds or Air Sides of Jet Bodies that are above the water line of the tub. We offer many different plugs based on the brand of manifold.

This part is a Manifold that features (6) 3/8" Barbs and is Flow Thru, 1-1/2"slip x 1-1/2"spigot.. To plug the barbs you can use these plugs: Barb Plug 3/8" Slip for Air Manifold and more Waterway Set of (3) Barb Plugs 3/8" Slip for Air Manifold and...

In this video The Spa Guy tells you the basics about diagnosing and replacing a M7 sensor on a Balboa Board.  Click this link for the m7 sensors on this site: M7 Sensor #sparepair #hottubrepair #spaguy...

This kit Fits Watkins, Vendor #4081, Wavemaster XP2 Pumps found under the name Wavemaster with the Vendor Code 4081 only.. Features (1) Seal for XP2 Pumps on Hotspring Watkins Hot Tubs, Seal Install Tool and (1) 1/2oz Tube of The Professor's Silly Juice...

This part is a La Spa Gecko Topside Control Panel K-72 Overlay Only 5 or 6  Button Skewed Style for 2 Pump, and a Light.  or (2) Pumps, Blower and Light.. Note: The 5 button version is no longer available but we still have the 6 button...

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This part is a Master Spa 8 Button Overlay for Master Spa Legend Series 2005-2012 Topside for a Three Pumps with Light. This Overlay can be used to replace your original Overlay with your brand on it as long as the button configuration works out...

This circulation pump is a 230V Replacement for a Power Right pump found in some Cal Spas.. This Pump is a 2" X 2" Wet End which measures about 3" edge to edge across the threads.. This pump is a 48 frame 230V Side Discharge wet end with a 2" suction...

This Item is a Board Fuse .05Amp Slo Blo MDA Style Ceramic Fuse that measures 1 1/8" Long x 1/4" Wide and is used on some Hot Tub or Pool Boards. This is a smaller automotive style fuse that does not have glass but used ceramic to dissipate heat. You...

This Jet Pump is found from the factory in many hot tubs and will be an easy installation for people who are handy.   This pump is a 56 frame XP2e 1.5HP 230V Side Discharge wet end with a 2" suction side and 2" pressure side which measures about 3"...