Top Draw Air ControlPart only

This part is a Bleeder Barb that is 3/8" barb x 1/4" Threaded MPT fitting fits Wet End Face Bleeder Plug Holes to attach a Bleeder Line it fits Waterway Executive 48 & 56 Frame Parts & Wetends, Power-Right 9089X, 9094X,...

Harwil Q12DS Flow Switch 1/2" NPT with 2 amp pilot duty switches. Switches on at 10 gpm and switches off at 8 gpm. ABS body, stainless spring arm. Used to protect your spa from heating without circulation. When this switch fails your hot tub may show...

This part is a Complete Jet Internal, CMP, Typhoon 300, 3" face diameter, Roto, 5 Scallop, Stainless Steel, Dark Gray.. NOTE: There are CMP Jets out there that look just like a Waterway but these diffusers will not fit.. Be sure you have a Waterway...

Anchor type handrails are often crushed at the end by the underground anchor causing the handrail to loosen and become unstable. When hammered into the crushed end of the handrail, the Handrail Stabilizing Plug rounds it out and provides a permanent...

"Magicmend" Pipe extenderSimply cut the bad fitting and remove it from the system. Glue the correct size Magicmend into place and replumb your new fitting

This part is a Pump Bleeder Barb with O-Ring that is found on some Aqua-Flo Xp2 and Xp2e wet ends but is used with an unusual bleeder line.. The line is 1/4" Inside Diameter not 3/8" Inside Diameter like most bleeder lines.. This part does come with the...