Vico, Big Foot Pump Impeller, Found on many different brands but on some Sundance Brand tubs too.. Closed face impeller made for the Big Foot spa pumps by Vico. Rated at 4.0hp,which would be 13-14.0 Amps.. Click here for the Seal for this impeller Vico...

This part is a Complete Heater Tube and Element that fits Vita Spas build by DM Industries.. Stainless steel 5.5kW/230v, 2" x 17-3/4" flow thru replacement heater assembly with a pressure switch tap at 0 degrees from the heater terminals. Includes a...

This part is a Waterway Short Body Power Series Jet Body Kit.. This Kit Includes the Jets Body, Flange, Gasket, a 2.8 Oz Tube of Silicon to Seal the Jet Body Back to the shell, 4" Of 3/4" Clear Tubing and (2) 3/4" Clamps along with a...

This part is a Waterway Short Body Power Series Jet Body.. This part has been discontinued by Waterway but we have some.. The Width of the face is 4 1/2", The Hole size is 3 1/2", the overall length of the jet body is 4 5/8" from the front to...

If this is not available the top of this drain will work: Lo-Profile Drain Assembly, 3/4" Slip or 1" Street, Gray, 1-15/16" Face Width with Silicone Kit This part is a Replacement Bottom Drain Fitting Kit found on Artesian and Resort Hot Tubs...

This Kit is a Renu Kit for 1" Street X (4) 3/4" Barbs manifold to be used to replace old manifolds with 3/4 or 1" glue in white pipes. The Manifold recieves a 1" pipe on the slip side which would measure about 1 1/4" inside...

This kit is a Renu Kit for 1" Street X (4) 3/4" Barbs manifold to be used to replace old manifolds with 1/2" glue in white pipes. The Manifold recieves a 1" pipe on the slip side which would measure about 1 1/4" inside...

This part is a 1" Street X (4) 3/4" Barbs manifold. The Manifold recieves a 1" pipe on the slip side which would measure about 1 1/4" inside Diameter and then glues inside of a slip on the street side on the other side...

This Part is NLA in White 2 5/8" Face Width Replacement Mushroom Knob for Waterway, Hydro-Air or CMP Brand Waterfall Control Valves.. If you order this you will receive a Gray one.. The Bottom Accepts a 5/8" wide Square Stem and we offer...

This item is a White Notched Replacement Diverter Cap for a 1" Waterfall or Neck Jet Control.. The inside thread measurement is about 1 5/8" and the center hole is about 3/4".. It uses (2) Small o-rings and one O-Ring Gasket that measures...

This 1" Waterfall Control Plunger Replacement Kit is found in some 1" Waterfall or Neck Jet Control valves. This kit features the plunger and stem, The Gasket for the bottom of the plunger and clip that holds the stem inside the cap and an o-ring kit for...

This part is a Jet body that is used with HydroAir Fixed 1 1/2" Wide Face Bullet or Ozone Style Jets...Rated at 3-4 gpm and requires a 3/4" hole in the shell.. The pipe connection is 1/2" which measures about 3/4" OD... For Jet Faces used with this body...