You are purchasing a 1HP Impeller, (1) Standard Bearing and 1000 Seal with Silicon and a Seal Install Tool that fits an Executive 48 Frame Wet End up to 2HP Motor and a 56 Frame Wet End 1HP Motor. This Impeller fits between the Face...

This part is a 10 LED Bulb to replace most standard spa lights. Colors are changed by switching the light on and off. *Commonly used in: Sunbelt Spas, Clearwater Spas  NOTE: This Light is not a controller it is a replacement like only....

You are buying a Kit that features (1) PS-201 Seal and (2) Bearings that fit most motors that are mated to Vico, Sta-Rite, Dura-Jet and Power Right Pump Wet Ends and The Professor's Silly Juice to seal the seal. This Seal is used in Most Vico,...

This Filter is a 40 Square Foot Filter Cartridge that is 6" Outside Diameter x 8 1/4" in Length. It has a 1 1/2" SAE Threaded Fitting which is a Thick Thread that measures about 2" outside diameter of the threads. SAE Threads are really thick. This...

You are buying a Balboa 4 Button Overlay for a Viking Spa Topside for a Pump and a Light. This is a Large Oval with the button configuration of Jet, Light, Cool, Warm left to right. This Overlay can be used to replace your original Overlay no matter...

This part is a MVP 260, VL260 Topside, Balboa, E4 Oval, Jets, Jets, Temp, Light works for 1 or 2 Pump Systems 7' Long Cord. It has an 8 pin Cat 5 Phone Style plug and a cord that is 84" long to work with some Viking Brand hot tubs where the...

This part is an Overlay for some Viking Spas, E4 Oval, Jets, Jets, Temp, Light works for 1 or 2 Pump Systems. Manufacturer    VikingButtons    4Topside Shape    Oval, Oval, ElongatedThis Over fit a...

This part is an Overlay, MVP 260, VL260, Balboa, E4 Oval, Jets, Jets, Temp, Light works for 1 or 2 Pump Systems. This overlay is found on many hot tubs with the tubs brand name on it but these are generic with the Balboa name on them....

Spa Jet Retaining Ring ToolCompact design gives full grip of fitting to eliminate bending that happens when plastic tools are used.Can be used with any spa jet with a retaining ring close to surface of the eyeball (e.g. Hydro-AirJets, Hay-SP1438)

Hydro-Air 6 Tip Wall Fitting ToolMetal tips of our tool grip recessed slots, better than the plastic tool that strips out easily.Use on Hydro-Air wall fitting with 6 recessed slots. (e.g. Hydro-Air standard wall fitting)

You are purchasing a New Balboa MAS470 Spa Hot Tub Board found in Master Spa and Down East hot tubs. This board is still available but is limited to stock on hand.   It supports up to 2 pumps with a blower and optional circulation pump. Has an...

You are Buying a Lo-Profile Drain Assembly, 3/4" Barb, Black, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one by simply adding silicon...