This Jet Pump is found from the factory Rarely in hot tubs so be sure you are choosing the correct one.   This pump is a 56 frame XP2e called 3.0HP I would call it a 2.0HP 230V Side Discharge wet end with a 2 1/2" suction side which measures...

This part is a Heater M7 Sensor with a 31" wire found in Jacuzzi Premium J series 2016 to current.  Note: This sensor does not have the nut and washer on it so it will only work with Jacuzzi Premium hot tubs..   Application Balboa...

  Filter, Cartridge, 30sqft, 1-1/4" Female SAE Thread, 4-3/4" Wide, 11-3/8" Tall Note: The 1 1/4" Thread is a very usual size are sure you are correct before ordering..   These are found on some Saratoga Hot Tubs.  Bottom Physical...

You are buying a Complete Replacement 5.5KW Heater Assembly that fits a Gecko SSPA or Spa Builders Pack. This Heater Assembly includes the Tube, Element, Split nuts, pigtail wires and Gaskets. The new version of this heater includes dettached pigtail...

This Vendor Code 3536 2.5 Horse Power Impeller, Seal, Silicon & Seal Installation Tool that fits a 56 Frame Pump Wet Ends manufactured by Intertek with numbers 39578-03, 37066-03 or 0982601-03 only.  See NOTES Below... Watch the video...

This part is a Wall Fitting , Hydro-Air, HAI, 3-Port Butterfly Jet, 3-1/4" Hole Size, White.. Jet Part Type    Wall FittingManufacturer    HydroAir/BalboaModel    3 Port ButterflyHole Size  ...

 This part is a Tread, SR Smith, Swan, 17-1/4", Plastic, White, Generic Note: If you are replacing the Inter-Fab treads you must replace all three for this to work..   Application Type LadderHandrail/Ladder Part Type Tread,...

This part is a Pump Bleeder Barb fit some Watkins Wavemaster LX Pumps and others.. It is 1/2" Barb x 1/4"Mpt and is used with an unusually large bleeder line.. The line is 1/2" Inside Diameter not 3/8" Inside Diameter like most bleeder lines.. This part...

As of 11/2024 Aqua-flo has started to send this pump with a capacitor bump in an odd spot that may affect your installation. In light of that we are now sending this pump assembly out as a separate 10.5 Amp motor and a genuine 2.5 HP XP2 wetend. You...

This part is a PVC Tee, 1"slip x 2"slip x 1"slip.. You can make your connection back to the small side using the below kit..  Connect kit for 1" Soft pipe Click Here.. 1" Connect Kit Jacuzzi J Pump Fittings found here: Jacuzzi® J Pump...

This part is a Complete VL-200 or Eco-200 topside that is used on some Balboa 4 button systems..  It features Jet, Temp, Light reading left to right.. It has an 8 pin Cat 5 Phone Style plug and a cord that is 72" long.. Compatible with the...

This Filter Core and Standpipe with Valve is made specifically for Oval Shaped Filter Cartridge that is 6-1/4" Outside Diameter on the Widest Part of the Oval x 9-3/4" in Length. Please don't be silly like Charles and think this is a filter and...