This is a back mount pressure gauge with a 1/4" MPT Threaded Mount used on Swimming Pool and Inground Style Hot Tub Sand and DE Style Filters. Hayward, Pentair, StaRite, Purex,Jacuzzi,Pacfab, Filter Gauge Type Pressure Mounting Type Back Mount Connection...

This part is a Starter Capacitor that fits many 115V Pump Motors. Start Capacitor, 161-193 MFD, 115v, 1-7/16" x 2-3/4" When diagnosing pumps for a no start condition where it is powered up but just hums you can hand spin start the motor by taking a screw...

This part is a (1) 90° 2" Slip X 2"Slip PVC Plumbing Fitting. The 90° ELL receives a 2" fitting on each side which would measure 2 3/8" Inside Diameter. Any 2"  fitting (which measures 2 3/8" outside diameter) will glue into this...

Large 4oz tube is the ideal size for the service professional's truck or repair bench! Stock a few extra as a backup! Lube Tube lubricates and seals with a patented barrier of PFTE. It's unique formula containing silicon dioxide eliminates the need for...

This part is a 2" Slip X 2" Slip X (4) 3/4" Ports Manifold open style. This part used in tubs where 3/4" softpipe which measures 1" OD glues inside the ports and goes to the back of each jet in the tub and is plumbed into 2" Pipe which measures 2 3/8" OD...

You are buying on a 25Amp Pressure Switch Universal Kit that features 1/8th" MPT Standard Threads and 2 Spade connectors for attaching the 2 wire connections and Some Brass Adapters to change the 1/8"mpt connector over to an 1/8" Barb or to a compression...

This part is a 90 Ell 1 1/2" Street X 1 1/2"Slip PVC Plumbing Fitting. The 90 ELL receives a 1 1/2" fitting on one side which would measure 1 7/8" OD and then slips into a 1 1/2" fitting on the other side that would measure 1 7/8" ID. It will Glue into...

This fitting is a PVC Tee that features (3) 3/8" Barbs that receives a 3/8" ID pipe on all three sides. Note: Colors can vary..   Barb Fitting Type Barb Tee Barb Size 3/8" Barb Type Barb (b) Plumbing Connection...

Aqua-Flo Xp2 Flo-Master 48Frame Pump Face O-Ring Only fits around the Face of a Xp Pump Face exclusively for An Aqua-Flo Xp 48 frame pump which has 2" inlet and outlet which measures about 3" across the threads... There are (2) Different versions of the...

This part is a Balboa Heater M7 Sensor. This Sensor comes with the wire, Connector, and The Screw down cap. It DOES NOT include the tube and the tube side mount. You will normally not need the sensor mount you would reuse it so there is no reason to...

This part is a Replacement Diffuser for a 2" Cluster Storm Jet made by Waterway. These jet diffusers are removed by pulling the Jet face away from the duffuser and onto the jet face. I also have the replacement jet in this store if you don't have all of...

This Seal is a PS-100 that fits a Starite Max-E Glas or Dura-Glas Swimming Pool Style Pump. This Seal is rarely found on Hot Tubs. Shaft Seal Head Type A Model PS-100 Quality/Material Good - Buna Graphitic Plastic Shaft Size 5/8" Seal Outside Diameter...