"Magicmend" Pipe extenderSimply cut the bad fitting and remove it from the system. Glue the correct size Magicmend into place and replumb your new fitting

This 115V Laing E-10 pump with a 3/4" Barb Suction and Pressure Side which measures about 3/4" Outside Diameter and the hose is 3/4" Inside Diameter  is compact and lightweight, less than 5 lbs. It is whisper quiet, highly efficient and designed...

This part is a Complete Jet Internal, CMP, Typhoon 200, 2" face diameter, Roto, 5 Scallop, Stainless Steel, Dark Gray... Note: You will receive the jet in the first picture as a replacement for the old version..  Note: This is a...

This part is a Tee, 2" Slip x 2" Slip x 2" Slip.. The ID of each connection is 2 3/8" and it will accept 2" Flex pipe in each connection.. PVC Pipe Fitting Type Tee First Plumbing Connection Size 2" First Plumbing Connection Type Slip...

This part is a Start Capacitor 108-130 mfd..1-7/16" diameter x 2-3/4" height Capacitor Type Motor Start Motor Brand A.O.Smith/Regal Beloit, Century/Regal Beloit, Franklin Electric, General Electric Microfarad Rating 108-130...

Valterra Pneumatic Activated and Cable Activated Gate ValveAvailable in a variety of sizes and configurations. Body material is black abs plastic and seals are made of santoprene material. Paddles may be plastic or stainless steel

This is a 1.5HP Impeller for an Aqua-Flo 48 Frame Side or Center Discharge FMHP, FMCP, FMVP, and TMCP Series Wet End 1.5HP Motor that has about 9.0 Amps on High Speed at 230V and 14.0 Amps at 115V. This Impeller fits between the Face and the Volute of...

This circulation pump is found from the factory in many hot tubs and will be an easy installation for people who are handy.   This pump is a 48 frame 230V Side Discharge wet end with a 1 1/2" suction side and 1 1/2" pressure side which measures...

This part is a Gray Notched 3 3/4" Spa Diverter Cap only.  This is a NON  Buttress Cap if your cap has the word Buttress stamped in it look in our store for a Buttress cap. This Diverter Cap mounts on top of the Diverter Valve with...

This part is a 90, Street Ell,  Elbow, 1" Slip x 1" Street/Spigot.. This part accepts a 1" Pipe or fitting on the slip side that would measure about 1 1/4" Outside Diameter and glues inside of a 1" fitting on the other side that would measure about...

This part is a Complete Jet Internal, Pentair, Cyclone Euro, 2" face diameter, Directional, 5 Scallop, Gray... Note: This is a Pentair Cyclone Euro Jet.. They do not offer a replacement diffuser for this jat and although it looks very much like a...