This part is a Wall Fitting Flange, Waterway, Poly Jet, 3-1/8" face diameter, 2-5/8" hole size, White.. I use Silicone to seal it not a gasket.. Click here for links to Silicone.. Silicon Medium Tube 2.8oz Special Hot Tub Repair Formula for Sealing...

This part is a box of (10) Light Bulbs.. These bulbs are the standard used in most Hot Tubs with Balboa, Gecko, ACC, Hydroquip, Len Gordon, Hurricane, and many more controls.. If your hot tub has a slip in spade style bulb this is probably the correct...

This part is a 2" Slip X Dead End X (4) 3/4" Barbs manifold and a single barb plug in case you only need 3 barbs instead of 4. The Manifold receives a 2" pipe on one side and then is a Dead End on the other...

Start Capacitor1-7/16"dia x 2-3/4"hgt

THIS PART IS THE Gasket USED on the bottom OF THE PLUNGER FOR A 1" WATERWAY SINGLE PORT ON/OFF VALVE ONLY..  Click here for the entire kit:   Internal Kit, Plunger Style, Waterfall Control, Diverter Valve, 1"

The UltraPure EUV3 UV Ozone Generator is being phased out and replaced with the UltraPure BFO3+ and that is what we will send. See the pictures for more detail With it's high level of Ozone output over a long life, the UltraPure EUV3 outlasts all leading...

This Filter cartridge is 5 5/16" Wide X 10 1/8" Tall.. It has a 2 1/8" hole on the top and bottom... it is 45 Sq Ft and is found in a lot of different brands... Dynasty Spas, Garden Leisure, Leisure Bay, Recreation Warehouse, Rainbow,Pentair,...

This item is a Clip that is used to hold the stem inside of the top cover cap on 1" Waterway Single Port On/Off Valves only..  Click here for the complete kit:   Internal Kit, Plunger Style, Waterfall Control, Diverter Valve, 1"

 This part is the slinger found between the impeller and wet end and the shaft going into the pump motor bearing area and is designed to sling water away from the bearing in case of a seal leak at the wet end.. Note: It has to be placed on the motor...

You are buying (1) Bearing that fit some motors that are used in hot tubs, usually small 48 frame motors and some circulation pumps, this bearing is 15.9MM ID x 40MM OD. Some of the motors this fits are A.O.Smith/Regal Beloit, Century/Regal Beloit,...

This part is a Jet Face, 1-3/4", HydroAir, Duo Blaster, 5 Scallop, Gray.. This jet has other parts the can be found in the below links and are sold separately: Retaining Ring, HydroAir, Duo Blaster, Roto, Gray, For 1 3/4" Face Flow Path, HydroAir, Duo...