This Kit is a Barb Adapter, 3/4" Barb x 2" Spigot to 3/4" Slip Kit, Fits 2" Slip Water Manifolds that features (2) Clamps, 4" 3/4" ID Tubing and (1) 3/4" Barb to 3/4" Slip /1" Street Fitting that will glue inside of a 2" Slip Manifold or other 2"...

This is a XP2e 3.0HP Impeller.. The Impeller has a 2 3/8" Eye width for an Aqua-Flo 48 or 56 Frame Wet End 3.0HP Motor would be about 12.0 Amps on high speed at 230V there are no 115V versions. Note: If your old impeller has a 2 3/8" Eye this is the...

This part is a Spring that fits Praher ABS 1-1/2" & 2" Top/Side Mount Valves..

This is a XP2e 2.5HP Impeller.. The Impeller has a 2 5/8" Eye width for an Aqua-Flo 48 or 56 Frame Wet End 2.5HP Motor would be about 11.0 Amps on high speed at 230V there are no 115V versions. See the links below for seals, bearing and other parts for...

This filter fits Jacuzzi Premium Hot Tubs J-300, J-400 Series. It is 15 1/2" Tall and 6 5/8" Around and Features a 2" SAE which is a Thick Thread and measures a hair less than 2" Inside diameter and measures 2 3/8" to the outside of the threads. There...

This Kit is an 2HP Impeller for an Executive 48 Frame Wet End up to 2HP Motor and a 56 Frame Wet End 2 HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you...

This part is a G&G Suction cover that measures about 4 7/8" edge to edge.. It has a single hole in the center and comes with a stainless screw to hold it into place..Cover Diameter    4-7/8"Suction Fitting Part Type  ...

This is a 2HP Impeller for an Aqua-Flo 48 Frame Side or Center Discharge FMHP, FMCP, FMVP, and TMCP Series Wet End 2HP Motor that has about 10.0 Amps on High Speed. This Impeller fits between the Face and the Volute of an Aqua-Flo FMHP, FMCP, FMVP, and...

This part is an Amp Style Male Pin crimp connector that fits wire that is 14-20 Gage and is usually found on the pump or other accessory side plug connector that is mounted on the cable.. This listing is 25 Pins..   Terminal...