Vico Ultima Ultra Flo or Ultra Jet Pump ImpellerClosed face impeller made for the Ultima and Ultra Flo spa pumps by Vico. Rated at 4.0hp,which is between 12 and 14 Amps.. it is used in an Ultima, Ultra Jet and/or Ultra Flo pump wet end, and must be...

The VS300 circuit boards have been discontinued. We now send the VS501Z circuit board which has a few more receptacles but is the same otherwise in fit and programming. This part is a VS300 Board that operates (1) Pump and Light..If your board has this...

This item is a 1/8" MPT Brass Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or...

This is a XP2e 2.0HP Impeller.. The Impeller has a 2 5/8" Eye width for an Aqua-Flo 48 or 56 Frame Wet End 2.0HP Motor would be about 10.0 Amps on high speed at 230V or 16.0 Amps on High at 115V. See the links below for seals, bearing and other parts...

Run Capacitor2"dia x 3-3/4"hgt

The "Smart" Check is equipped with a 1/2Ó lb spring-loaded gate mechanism, allowing the valve to be installed in virtually any orientation.

Unibody PVC Gate Valve SPG x SPG