StaRite/Pentair Dura-Glas II/MaxEPro Pump Impeller for a 1.5HP Pool Pump... Please check your impeller against the measurements below..Closed face impeller made for the Dura-Glas II and MaxEPro pool pumps by Sta-Rite/Pentair. Rated at 1.5hp, it is used...

You are Buying 2X Waterway Spa Hot Tub 1 1/4" Air Jet Face, Flange Style Fittings with 3/4" Thread Injector Part. This Part is installed by adding clear silicon to the flange and screwing the flange into the jet body using an allen wrench. ...

This part is an 11 button Gecko Aeware topside complete with a 10ft cord that is used in systems base on the IN.K600 part number.. Dimensions 4-1/4" x 8-11/16" With its stunning design, Aeware by Gecko's new in.k600 advanced control panel features a low...

This filter is Designed for the Coast Hot Tubs 21 5/16 tall X 5 5/16" and has 2 1/8 holes top and bottom...  And fits   Diameter 5-5/16" Length 21-5/16" Top Style Open Top Physical Dimension 2-1/8" Bottom...

We are offering a Pre--2002 Master Spa Cartridge Filter 8" x 9 1/4" Wide 2"mpt 70sqft Master Spa Most 1998,1999, 2000. This filter is 8" long x 9 1/4 " Wide and has   2"MPT which measures about 2 1/4" Across . The overall length of this housing...

This Set is a Set of (2) Reinforced Smooth Gray 4" Spa Diverter Handle Knobs only.  These Diverter Knobs has a smooth top for a more classic look and easier handling as well as a reinforced receiver and mounts on top of the Diverter Valve...

This Face Plate O-Ring Is 5 1/8" Inside Diameter and is 1/8" Thick. It is found on Aqua-Flo 1 1/2" x 1 1/2" (Which Measures 2 3/8" Outside of the threads on the Sunction and Pressure Side of the Wet End) These Wet Ends used the names Flo-Master,...

This Mixing Chamber Repair Kit fits the American Products Pentair Luxury Micro Jet body's that are used with the (2) Tab Style Jets that are pictured in the photo section with the measurements and are used to be able to turn off the water flow from the...

Drain Plug with O-Ring for Waterway Wet Ends Fits Executive, Viper, Hi- Flo, Iron Might, Spa Flo, Supreme, Mustang, Workman and More  We also offer the 3/8" Barb that replaces these plug in the case of using a Pump Bleeder System... This are found...

This Wear Ring only fits Waterway Executive 4 or 5HP Impellers for a 48 or 56 Frame Pump Wet Ends and measures 13/16" thick from front to back or some Intertek impellers... If you have a Waterway Executive 1,2 or 3 Horsepower Wet End it will require...

This Tool is used to install Luxury Micro Jet Body Front Flanges... SEE THE FLANGES AND ALL OTHER RELATED PARTS BELOW HERE:  Wall Fitting Gasket, BWG/Pent Luxury Micro Jet Silicon Small Tube 1/2oz Special Hot Tub Repair Formula for Sealing...

This Jet body Fits an American Products Pentair Luxury Micro Jet that has (2) Tabs to hold it into the Jet Internal.. The Water fitting is  1" Slip glue in Fitting that can be plumbed into one side and capped on the other side or plumbed in series...