This part is a Jacuzzi® J Pump Style Pump Union that can be used on 1 1/2" or 2" Plumbing systems. This union can receive a 1 1/2" plumbing part inside the back of the union or a 2" Plumbing part glued to the outside of the...

This is a Balboa Temperature & Hi Limit Combination. This is a standard part and fits most Balboa 4 pin applications that are no M-7. It features a 4 pin connector will Curley Finger style ends and the Temperature Sensor Cable is 96" long and the Hi...

Spa or Small Pool Floating Dispenser (1" tabs) Floating Feeder Complete Complete Floating Feeder Tablet Size 1 inch Color Blue Manufacturer Rainbow/Pentair

This part is a Run Capacitor that fits many 230V Pump Motors. When diagnosing pumps for a run capacitor concern you will find high amp draw, overheating, Noise and other concerns. This type of capacitor is really hard to dioagnose unless it is not...

This part is a (1) Sweep 90 2" Street X 2"Slip PVC Plumbing Fitting. The Sweep 90 ELL receives a 2" fitting on one side which would measure 2 3/8" and then slips into a 2" fitting on the other side. It will Glue into any 2" fitting to make a tight...

This Item is a 30Amp Slo Blo MDA Style Ceramic Fuse that measures 1 1/4" Long x 1/4" Wide and is used on some Hot Tub or Pool Boards. This is a smaller automotive style fuse that does not have glass but used ceramic to dissipate heat. You will not be...

Stainless Steel Worm ClampFits 1-3/4" to 2-3/4" od Hoses or Tubing

This item is a Plastic Pinch Style Tubing Clamp that works on 1/2" Tubing which has a 3/4" OD.

This O-Ring can be found in some American Products, AquaFlo, Gecko, Hayward, Sta-Rite, Pentair, Sonnafarrel, Martec, Advantage, Filter housings to seal the multiport. Application - Category Filter, Cartridge, Pump, Pool Application Manufacturer American...

This is a 3/4" Spigot Plug which measures 1" OD it is used to plug off a 3/4" port which measures 1" ID on a manifold or other fittings.

This Item is a 3/4" Threaded Flow Switch with Housing that is found in Jacuzzi Premium, Sundance Spas and a Few other Brands. The Housing is 3/4" Barb X 3/4" Barb X 3/8" Barb. Note: Some housings don't have the 3/8" Barb if yours doesn't you need to...

This part is a Starter Capacitor that fits many 230V Pump Motors. When diagnosing pumps for a no start condition where it is powered up but just hums you can hand spin start the motor by taking a screw driver to the shaft in the back and spinning it or...