Inside Pipe Repair Glues Inside 2" Pipe on both ends. Magic Mend Simply cut the bad fitting off of 2" hard pipe and remove it from the system. Glue the 2" size Magicmend in between two peices of 2" ID pipe to mend pipe back together..

For use with the in.clear bromine generating system by Gecko.1.2 lbs per 100 U.S. gallons is required on initial fill.

This Part is a Back Light Bulb for a Balboa Topsides only. Backlight Bulb Used In Balboa Water Group Digital Topside Controls Series 701 and 724 You will need a Small Flat Screwdriver to remove and install this bulb. Note: Not all Balboa Topsides have a...

This part is a 2" Spigot X 2" Slip Slice Gate Valve. The Valve recieves a 2" pipe or fitting (Which is about 2 3/8" Inside Diameter) on one side and then slips inside of a 2" fitting (Which is about 2 3/8" Outside Diameter) on the other side. This part...

"You are buying a Techmark 4000 Series 25Amp Pressure Switch with a Plastic Bottom and top that features 1/8th"" MPT Standard Threads and 2 Spade connectors for attaching the 2 wire connections. This Switch will fit Balboa, Gecko, ACC, Hydroquip, Len...

This part is a 2" Spigot X 2" Slip Slice Gate Valve. The Valve receives a 2" pipe or fitting (Which is about 2 3/8" Inside Diameter) on one side and then slips inside of a 2" fitting (Which is about 2 3/8" Outside Diameter) on...

This is a Flat Gasket for 2" Pump or Heater Union Extra Thick 1/4". It is a 2 7/8" Outside Diameter and 2 1/8" Inside Diameter.

Insta-Test® Instant Water Test StripsThe only instant water test strip on the market today. Spa techs andconsumers will love the convenience and simplicity ofinsta-Test®Pop-top caps on vials provide moisture protectionTest Type Chlorine/Bromine...

AMP Plug Housing Male Cord Side 4 Pin 20 amp style. Note: This plug does require a tool to remove the pins to change this plug housing...   Terminal Type AMP Terminal Style AMP Plug Housing Male Number of...

This part is for a Standard Balboa Board Replacement Repair Relay made by Zettler. This Relay is the standard relay found on most Balboa Boards but it has double tabs on it so you can add jumpers from the tabs to the feed and load side of the circuit to...

You are buying on a 2" Slip X 2" Heater Union with Gasket. The Union receives a 2" pipe or fitting on one side that measures about 2 3/8" Outside Diameter and then Screws to a 2" Heater Flange Split Nut on the...

This part is a (1) 45 Degree 1 1/2" Street X 1 Slip PVC Plumbing Fitting. The Union glues into a 1 1/2" fitting on one side and then receives the fitting on the other side. It will Glue into any 1 1/2" PVC fitting to make a tight plumbing application...