This part is a 90 Ell 1 1/2" Street X 1 1/2"Slip PVC Plumbing Fitting. The 90 ELL receives a 1 1/2" fitting on one side which would measure 1 7/8" OD and then slips into a 1 1/2" fitting on the other side that would measure 1 7/8" ID. It will Glue into...

This fitting is a PVC Tee that features (3) 3/8" Barbs that receives a 3/8" ID pipe on all three sides. Note: Colors can vary..   Barb Fitting Type Barb Tee Barb Size 3/8" Barb Type Barb (b) Plumbing Connection...

Aqua-Flo Xp2 Flo-Master 48Frame Pump Face O-Ring Only fits around the Face of a Xp Pump Face exclusively for An Aqua-Flo Xp 48 frame pump which has 2" inlet and outlet which measures about 3" across the threads... There are (2) Different versions of the...

This part is a Balboa Heater M7 Sensor. This Sensor comes with the wire, Connector, and The Screw down cap. It DOES NOT include the tube and the tube side mount. You will normally not need the sensor mount you would reuse it so there is no reason to...

This part is a Replacement Diffuser for a 2" Cluster Storm Jet made by Waterway. These jet diffusers are removed by pulling the Jet face away from the duffuser and onto the jet face. I also have the replacement jet in this store if you don't have all of...

This Seal is a PS-100 that fits a Starite Max-E Glas or Dura-Glas Swimming Pool Style Pump. This Seal is rarely found on Hot Tubs. Shaft Seal Head Type A Model PS-100 Quality/Material Good - Buna Graphitic Plastic Shaft Size 5/8" Seal Outside Diameter...

This part is a (1) 1 1/2" Slip X 1 1/2"Slip Coupler PVC Plumbing Fitting.   The Coupler receives a 1 1/2" fitting which measures 1 7/8" OD on one side and then receives a 1 1/2" fitting which measures 1 7/8" OD on the other side...

Inside Pipe Repair Glues Inside 2" Pipe and allows a 2" Slip to be glued over or a 1 1/2" Slip to be glued inside. Magic Mend Simply cut the bad fitting off of 2" hard pipe and remove it from the system. Glue the 2" Spigot Street end of the Magicmend...

Barb Adapter 3/4" Barb x 1/2" Spigot , The Glue Side glues inside a 1/2" Fitting which would measure 3/4" and a 3/4" ID tube would be glued over the barb.

This Part is a Waterway Old Style Jet internal that has no face flange trim. It simply screws into the jet body Right Hand Thread using the 4 tabs behind the nozzle. Usually the jet body flange is covered by a Chrome Ring to cover the jet body flange...

This part is a Replacement Diffuser for a 5"- 5 1/2" Wide Faced Storm Jet made by Waterway. Watch the below videos for more information on this type diffuser and installation instructions as well.. These jet diffusers are removed by pulling the Jet...

This Kit is an 4HP Impeller for an Executive 48 Frame Wet End up to 4HP Motor and a 56 Frame Wet End 4HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...