This Item is a Board Fuse .05Amp Slo Blo MDA Style Ceramic Fuse that measures 1 1/8" Long x 1/4" Wide and is used on some Hot Tub or Pool Boards. This is a smaller automotive style fuse that does not have glass but used ceramic to dissipate heat. You...

This Jet Pump is found from the factory in many hot tubs and will be an easy installation for people who are handy.   This pump is a 56 frame XP2e 1.5HP 230V Side Discharge wet end with a 2" suction side and 2" pressure side which measures about...

This part is a Complete Jet Internal, Waterway, Poly Jet, Caged Straight, Black, 2" Face Width.. This Jet is similar to the Poly Jets with the face that slips in and out except it has no face just a body..  Jet Part...

This part is a 3 Wire Thermostat replacement found in some Air Button Topsides that require 3 wires to operate.. Single pole rated at 25 amps with max temp rating at 107°F. Best results are obtained when the bulb is installed in a dry well or groove...

This part is a Balboa 6 Button Overlay for a VL620S or VL600 Topside with Two Pumps and Light System. On the overlay starting at the left of the readout it reads Jets, Jets, Light and to the right is Warm, Mode, Cool. This Overlay has an Adhesive back...

This kit is a New Style Jacuzzi® Premium or Sundance Spa Diverter (3) Piece O-Ring Kit only. This Diverter O-Ring Kit Features (1) Small O-Ring that fit on the Stem sealing the inside of the cap and (1) Medium Size O-Ring that fits on a disc...

This kit is a Repair kit for a 2007+ 4" Wide Capped JACUZZI® Premium J Series 300 and some 400 Model Spa Diverter Valves. This Kit comes with The Cap, Handle, Stem Gate Valve, (2) Small O-Rings and (1) Large O-Ring. The Valve...

This part is a 5 1/8" Master Spa, Down East or Freedom Spa Jet. This Jet is 5 1/8" across the Face Single. It features a single Hole Spinning black nozzle.  

This video is about The Spa Guy showing you how to replace a freeze damaged pump pressure side pump union , slice to the flex pipe where it was freeze damaged... #dynastyspa #dynastyhottub    #sparepair #hottubrepair ...

This Kit is a 45° 2" Pump Union To Plumbing Connect Kit found in many Dynasty Brand Hot Tubs. The Pump Union which measures about 3" Inside the threads glues into a 2" Slip X Slip 45° fitting on one side and then a 2" Slice Valve Glues...

This O-ring is used on some 1 1/2" Pump Union that measures 2 1/8" Center to Center of the o-ring groove.. Part Type    O-RingJet Part Type    Gasket/O-RingCross Section    1/8"Union Fitting...

This Kit is a Universal Air Bleeder Connect Kit with (1) 1/4" Mpt X 3/8" Barb Plug, (1) 3/8" x 3/8" Barb Coupler, (4") of 3/8" Clear Tubing and Silicon sealer usually used on Hot Tub Pump Faces to bleed the air off the pump while filling the tub up. I...