This part is a La Spa Gecko Topside Control Panel K-72 Overlay Only 6 Button Skewed Style for 2 Pump, Blower and a Light.    6 Button La Spa Gecko Topside Control Panel K-72 OVERLAY ONLY   Used In S-Class Systems Top Row:...

This kit is used to repair The air Bag Retaining frame instead of replacing it.. What happens is the rubber standoffs get weak and the horn button frame makes contact and will not move back after so the horn blows all of the time..  Watch video in...

This Tool is a Die that fits all American made Hot Tub Pump shaft threads.. This fits Hot Tub Pumps only in these brands.. Waterway, Aqua-Flo, Sta-Rite, Vico and Power-Right.. Note: This will NOT for LX Intertek Motor Shaft... 

This part is a Balboa 6 Button Topside that is called a Balboa E6 with a (4) Molex plug end.  You will also find a similar size and shape and look topside with a Phone style plug not a Molex style.. TP600, (4) Pin Molex Plug, (2) Pumps, Flip, Warm,...

This part is a Gray 3 5/8" Handle Knob for a 4" Wide Sundance® 3 Way Spa Diverter Valve. This Item is the Handle Only. The Valve this parts fits is found on Sundance® Spas only!!  Compare the measurements to be sure this...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Reducing Tee that is 1-1/2" Slip x 1/2" Female Pipe Thread x 1-1/2" Slip... The 1 1/2" Sides receive pipe and fittings that would measures about 1 7/8" OD on each end and a 1/2" Female pipe thread 3/4" OD..

This Manifold is  1 1/2" input which measures 1 7/8" Inside Diameter x (4) 1" outputs that measure 1 1/4" Inside Diameter.  Note: These manifolds are new old stock so they will not be perfect aesthetically...   Barb/Port...

This part is a Reducing Tee that is 1-1/2" Slip x 1/2" Slip x 1-1/2" Slip... The 1 1/2" Sides receive pipe and fittings that would measures about 1 7/8" OD on each end and a 1/2" pipe or fitting that would measure about 3/4" OD..

This part is a Reducing Tee that is 1-1/2" Slip x 3/4" Female Pipe Thread x 1-1/2" Slip... The 1 1/2" Sides receive pipe and fittings that would measures about 1 7/8" OD on each end and a 3/4" Threaded fitting that would measure about 7/8" OD like a...

This kit is a Dark-Sliver-Glitter, Hot Tub Replacement Bottom Drain Kit with a 3/4" slip barb fitting which measures about 3/4" O.D.. The kit that is it comes with is used to convert the old style 3/4" to 1" Flex Lines to a 3/4" Barb set up.. This...