Pump Impellers

This is a .5HP or 1/2HP Impeller for an Aqua-Flo 48 Frame Side or Center Discharge FMHP, FMCP, FMVP, and TMCP Series Wet End .5HP Motor that has about 6.0 Amps on High Speed at 230V and 6-7.0 Amps at 115V. This Impeller fits between the Face and the...

Aqua-Flo Xp2 6.1" or 6.3"and XP2e Flo-Master Pump Face O-Ring fits around the Face of a Xp2 Pump Face exclusively for An Aqua-Flo Xp2 pump which has 2" inlet and outlet which measures about 3" across the threads... There are (2) Different versions of...

This wear ring measures 2 3/8" inside Diameter and fits only 3.0HP Aqua-Flo XP2e and Xp3 Impellers.. If you have 1.5, 2.0, 2.5 or 4.0HP they require a different Wear Ring which measures 2 5/8" Inside Diameter.. Look at the chart in the photo section...

Waterway Viper Pump 5.0 Impeller exclusively for a Waterway Viper pump which has 2 1/2" inlet and outlet which measures about 3 9/16" across the threads...I have found this 5HP pump impeller to be on a 14-16 amp motor...   Closed face impeller...

Waterway Viper Pump Volute fits on the front of a Viper Pump exclusively for A Waterway Viper pump which has 2 1/2" inlet and outlet which measures about 3 9/16" across the threads... Click Here for the Face Plate Click Here for the Face Plate...

Waterway Viper Pump Face Plate fits on the front of a Viper Pump exclusively for A Waterway Viper pump which has 2 1/2" inlet and outlet which measures about 3 9/16" across the threads... Click Here for the Face Plate O-Ring This pump uses a different...

Waterway Viper Pump Face O-Ring fits around the Face of a Viper Pump exclusively for A Waterway Viper pump which has 2 1/2" inlet and outlet which measures about 3 9/16" across the threads... This pump uses a different seal than all other Waterway pumps...

Waterway Viper Pump Impeller Wear Ring exclusively for A Waterway Viper pump which has 2 1/2" inlet and outlet which measures about 3 9/16" across the threads... This pump uses a different seal than all other Waterway pumps click here for the Seal Kit...

Waterway Viper Pump 3.0 Impeller exclusively for A Waterway Viper pump which has 2 1/2" inlet and outlet which measures about 3 9/16" across the threads...I have found this 3HP pump impeller to be on a 10amp motor... This pump uses a different seal than...

In this Video The Spa Guy tells you How To Replace a Waterway Executive Pump Seal,,Impeller & Bearing... Save Save Save Save Save Save Save Save Save Save Save Save Save Save Save Save Save Save

In this Video the Spa Guy show you how to install a 200 seal in an Aqua-Flo Wet End.. This is the seal only version... For the full version look in The Spa Guy's How To Video Library.....

In this Video The Spa Guy Repairs a Aqua-Flo XP2e pump that was leaking.. He replaces the seal and impeller and cleans the shaft up.. The bearing was not bad so no need to replace that....