This parts is a Gray Weir Door that fits Waterway slide down front door covers that usually have (2) PWW-50 style 1 1/2" SAE Thick Thread style Filters.. This door measures about 14" wide and 5 1/4" tall and it has pins built in on each bottom side that...

This item is a Replacement Diverter Cap and O-ring Kit for a 1" Waterfall or Neck Jet Control.. The inside thread measurement is about 1 5/8" and the center hole is about 3/4".. It uses (2) Small o-rings and one O-Ring Gasket that measures about 1...

This part is a Starter Capacitor that fits many 115V and 230V Pump Motors. When diagnosing pumps for a no start condition where it is powered up but just hums you can hand spin start the motor by taking a screw driver to the shaft in the back and...

This parts is a Weir door that fits Waterway slide down front door covers that usually have (2) PWW-50 style 1 1/2" SAE Thick Thread style Filters.. This door measures about 14" wide and 5 1/4" tall and it has pins built in on each bottom side that...

This Part is an 48 Frame 2.0HP TMCP Aqua-Flo Wet End for a Garden Tub Bath Pump that has a voltage of 115V and an Amperage of about 16 Amps..  Note: The outside measurement of the threads on this wet end are about 2 3/8" meaning the inside...

This Part is an 48 Frame 1.5HP TMCP Aqua-Flo Wet End for a Garden Tub Bath Pump that has a voltage of 115V and an Amperage of about 14 Amps..  Note: The outside measurement of the threads on this wet end are about 2 3/8" meaning the inside...

This Part is an 48 Frame 1.0HP TMCP Aqua-Flo Wet End for a Garden Tub Bath Pump that has a voltage of 115V and an Amperage of about 12 Amps..  Note: The outside measurement of the threads on this wet end are about 2 3/8" meaning the inside...

This Part is an 48 Frame 3/4HP TMCP Aqua-Flo Wet End for a Garden Tub Bath Pump that has a voltage of 115V and an Amperage of about 10-11 Amps..  Note: The outside measurement of the threads on this wet end are about 2 3/8" meaning the inside...

This item is a Modified 2 1/2" Heater Union Tailpiece with a Pressure Switch Tap and Gasket that is used on may heater tubs that measure about 3" inside diameter of the tube.. It also has a 90 degree 1" Barb fitting.. This Union has had a Pressure Switch...

This part is a 2 1/2" Heater Split Nut with a Gasket which measures 3 9/16" Inside Diameter of the threads and 3" inside the ceneter part that wraps around a heater tube or body. The Heater Flange Split Nut mounts to the heater tube using 2 screws to...

This part is a set of (2) Bearings that fit most motors that are used in hot tubs, this bearing is 17MM ID. Some of the motors this fits are A.O.Smith/Regal Beloit, Century/Regal Beloit, Franklin Electric, General Electric NOTE: Installing bearings...

This pump is a Jacuzzi J-Pump, .75 HP, 48 frame, 115V, Single Speed with a J Pump Style Wet End  that measures about 2 15/16" across the threads on both the suction and pressure side connections..  Note: This Pump will Only Work in Jacuzzi J...