This part is a Direct replacement sensor kit for Watkins No-Fault 4000 or 6000 heater.Includes: Temperature Sensor, Hi-Limit Sensor, and (2) Two rubber O-Rings with newer Style Connectors 2002+.  Sensor Application Spa Control Sensor...

This part is a (1) American Products Luxury Jet Body Flange Tool. This Flange that this tools fits has two holes on the front that this tool fits into and the holes are between 2 1/2 and 2 5/8" apart.. The flange fits though a a 2 5/8" Hole in the shell...

We are offering a Cartridge Filter 9 1/4" Tall x 6" Wide 2"mpt 40sqft and fits newer Master Spa Legend and Twilight Series tubs as a replacement for the Microban filter previously used.  This cartridge is comparable to the Master Spa...

This part is (1) Replacement Diffuser for a 3" to 3 5/16" Threaded Waterway Mini Storm Jet.  Note: This part is a Waterway Threaded Mini Storm Jet back diffuser.. Also these jets look very similar to non Threaded Mini Storm and CMP jets...

This part is a 1 Quart Bottle of Metal Control only... This Chemical helps prevent metal staining surfaces and clear discolored water from high metal content..  We do offer this in a Kit and here is a how our system works.. Here is...

Due to a Chemical Shortage the brand of this product will vary but the makeup of it will be the same.. This part is a 2lb Bottle of Non-Chlorine Shock Granuals only... This Chemical Replaces Super Chlorination and Destroys irritating &...

Due to a Chemical Shortage the brand of this product will vary but the makeup of it will be the same.. This part is a 2lb Bottle of Chlorine Granuals only... We do offer this in a Kit and here is a how our system works.. Here is the system.....

This pump is a rated 5HP Viper 2 1/2" x 2 1/2" 56 Frame Spa Pump... The measurement from the edge of the thread to the edge of the thread on the Suction and Pressure side is 3 11/16"..  It is an unusual pump not found in most hot tubs.. It is...

This pump is a rated 4HP Viper 2 1/2" x 2 1/2" 56 Frame Spa Pump... The measurement from the edge of the thread to the edge of the thread on the Suction and Pressure side is 3 11/16"..  It is an unusual pump not found in most hot tubs.. It is...

This 5 3/4" Inside Diameter O-Ring fits around the face of a Waterway HI-Flo 48 Frame Wet End all Horsepowers and fitting sizes... This is (1) O-Ring ONLY!! As you can see below it fits other pumps and filter housings as well.. Part...

This part is a PC Board Plastic Standoff Holder Kit 1/4" long, Reverse Lock Style, Pack of 12, Fits Balboa and some other Brands...  We also have the 3/4" Version Here: Click for 3/4" Standoff Kit 

This part is a Stationary Switch, Century, Wishbone, 2 Speed, Pump, Motor, Switch.. The thing that happens to this switch is one of the phenolic pads on the edge of the wishbone falls off and the motor will not start in low speed because the wishbone...