This is a 4HP Seal, (1) Bearing and Impeller Kit.. The Impeller has a 2 1/8" Eye width for an Aqua-Flo 48 or 56 Frame Wet End 4.0HP Motor would be about 14.0 Amps on high speed at 230V. Note: The three things you need to know to get the correct Aqua-Flo...

You are buying a Kit that features (1) PS-200 Seal and (2) Bearings that fit most motors that are mated to Aqua-Flo Pump Wet Ends as well as Waterway " Viper" Wet Ends, The Professor silly Juice to seal the seal. This Seal is used in Most Aqua-Flo...

This part is a Complete CMP Bottom Drain Suction that is VGB Comaptible and requires a 3 5/16" Hole..  Suction Fitting Complete    Complete Assembly, StraightHole Size    3-5/16"Cover Diameter  ...

NOTE: This part is obsolete but we do have an alternative camp that will work but it is Dark Graphite Gray. If you order this Teardrop cap you will get the 6 spoke cap instead.. This part is a Cal Spa 1" Spa Hot Tub Air...

Dimensions 3-1/4”x7”This TSC-8/K-8 control panel will work with most MSPA systems, has 10 buttons including filtration cycle and Economy mode buttons, and will control three pumps and an air blower. It has an LCD display and comes with a 10ft...

This part is a Complete 5" Typhoon 500 Series Jet, CMP, Multi-Port Power Jet, Stainless Steel & Gray  Face Width is 5", The Hole Size is about 3 1/2", The water connection on the back is a 2" Street meaning you would glue a 2"...

This part is a Complete 1 5/8" Face, Jet Assembly, Waterway, Ozone, Swirl Face, 1 1/8 to 1 1/4" Hole Size, 3/4" Barb, Gray..  This part does not come with a gasket and will require silicone found here: 1/2 Oz Silicone

This part is a Complete 1 5/8" Face, Jet Assembly, Waterway, Ozone, Swirl Face, 1 1/8" to 1 1/4" Hole Size, 3/4" Barb, Dark Gray.. 

This part is a Complete Jet Assembly, CMP, Ozone, Smooth Face, 1 5/8" Face, 1 1/8-1/4" Hole Size, 3/4" Barb, Gray in color.. 

This part is a Complete 5" Typhoon 500 Series Jet, CMP, Multi-Port Power Jet, Gray  Face Width is 5", The Hole Size is about 3 1/2", The water connection on the back is a 2" Street which would glue inside of a 2" fitting that would measure...

This part is an Impeller for a 48fr Vico Ultima or Ultra Flo, 0.50hp, Jet or Circulation Pump... Closed face impeller made for the Ultima and Ultra Flo spa pumps by Vico/Balboa. Rated at 1/2hp, it is used in an Ultima and/or Ultra Flo pump wet end, and...

This part is a 3 11/16" ID Gasket for a Pentair, Cyclone Jet Body for 4 3/4" Wide Face Jet Body..   Part Type Gasket Jet Part Type Gasket/O-Ring Manufacturer Balboa Water Group Model Cyclone Inside...