Electronic Control Systems and Parts

Balboa VS100 circuit board and heater kit made to replace the discontinued VS100 spa pack and the previous versions of their retro-fit kits. This circuit board will fit into any previous VS100 or Dreammaker RS101 box. The 10" heater is rated at 1.0 KW at...

HydroQuip WaterPro retro-fit control system with 5.5 KW 15" slide heater. This Balboa BP7 based system has a heater that can slide up and down the back of the box or be detached to meet various plumbing setups. The unions on this heater are considered 2"...

Bullfrog Spas OEM BFBP20R1(x) circuit board made by Balboa. This circuit board has been used in many 2013-2018 models and can be used with a few different topside controls but is often paired with the touch screen models.  This circuit board will...

AMP cable splitter for use with Gecko or Balboa spa packs. This 14/3 splitter is commonly used for the circulation pump and the ozonator to share one receptacle on the main circuit board. It has a 6" length with one male AMP plug and 2 female AMP...

Sundance and Jacuzzi Flow Switch for 2006-2009 models. Jacuzzi used this switch on all 400 Series models 2006-2009 and in various Sundance models, including in ground units. Includes the tee with mounted flow switch, 5 ft cable and box end connectors...

Balboa "Y" Splitter used to add an additional Pump # 4 on BP spa packs and control systems such as the BP7 and BP2000. To utilize this splitter you plug the male end into the Pump 2 port, go into the programming and set pump 2 as a 2 speed circuit, then...

Balboa BP2000 retro-fit control system with TP700 Color LCD topside control panel. This high end BP2000 system is Balboa's top of the line unit offerring multiple pump support and feature rich settings for filtration, purge times and much more. This...

This part is a 72" AMP Style 3 Wire Cord With Male Plug that is used on a 1 speed pump or blower.. Note: To use this cable with a blower you will cut the spade connector off the end off the end and attach with crimp connectors.  The Wire colors are...

This part is a 60" AMP Style 3 Wire Cord With Male Plug that is used on a 1 speed pump or blower.. Note: To use this cable with a blower you will cut the spade connector off the end off the end and attach with crimp connectors.  The Wire colors are...

This part is a Amp Cord, Pump 1, 2-Speed, 4-Pin Amp, 14/4, 96" Long, Plug Attached, w/Terminated Ends. The Wire colors are as follow on most systems: Red=High Speed Black=Low Speed White=Neutral or Common Green=Ground There are exceptions to these...

Balboa BPBEE Control System with 4.0kW Remote Heater and TP200T Panel. Includes Blackout Plate, Hang Mounts, Topside and Light Wire..  You would reuse your amp cables for pumps and blowers.. If your original control used cords other than Amp Cables...

HydroQuip Temperature Sensor, 72" with 1/4" diameter temp probe. Common to find these used on the Versi Heaters and 9700 series spa controls. For SSPA, USPA, MP, 6200, 9200, 6500, 7500, 8500, 9500, 9700, 6330, 9330 series of spa packs and controls by...