This part is a 72" AMP Style 3 Wire Cord With Male Plug that is used on a 1 speed pump or blower.. Note: To use this cable with a blower you will cut the spade connector off the end off the end and attach with crimp connectors.  The Wire colors are...

This part is a 60" AMP Style 3 Wire Cord With Male Plug that is used on a 1 speed pump or blower.. Note: To use this cable with a blower you will cut the spade connector off the end off the end and attach with crimp connectors.  The Wire colors are...

This part is a Amp Cord, Pump 1, 2-Speed, 4-Pin Amp, 14/4, 96" Long, Plug Attached, w/Terminated Ends. The Wire colors are as follow on most systems: Red=High Speed Black=Low Speed White=Neutral or Common Green=Ground There are exceptions to these...

This part is a Latching (Locking) gas shock for the original Cover Valet 200 or 250 that was made of Stainless Steel. This shock will snap onto the arm, no hardware needed. This shock measures about 18" long has a ball style snap in on one end and a...

Balboa BPBEE Control System with 4.0kW Remote Heater and TP200T Panel. Includes Blackout Plate, Hang Mounts, Topside and Light Wire..  You would reuse your amp cables for pumps and blowers.. If your original control used cords other than Amp Cables...

Tis part is a Valve & Cap, Drain that offers a 1/2" slip or 3/4" barb connection. The hole size to mount this drain is about 1 1/4".   Drain Valve Complete    Drain Valve AssemblyHole Size    1 1/4"Hole Size Fitting...

HydroQuip Temperature Sensor, 72" with 1/4" diameter temp probe. Common to find these used on the Versi Heaters and 9700 series spa controls. For SSPA, USPA, MP, 6200, 9200, 6500, 7500, 8500, 9500, 9700, 6330, 9330 series of spa packs and controls by...

This Kit consists of 6" of 1" Inside Diameter Clear Tubing, (1) 4oz BLue Glue (2) Clamps and a 1/2" Coupler.. This Kit is used to convert your 1/2" or 3/4" Jet Body flex pipe connection that is leaking to a more modern outside barb type seal... You...

This part is a This newly designed gray pillow serves as the exclusive factory replacement part for Tiger River Bengal, Caspian, Sumatran, and Siberian spa models manufactured between 1998 and 2010. It also replaces the obsolete 72600 & 72599...

This fitting is a PVC Tee that features (3) 3/8" Smooth Barbs that receives a 3/8" ID pipe on all three sides. Note: Colors can vary.. The Smooth Style and Barbed Style both work well with vinyl tubing as in most cases 3/8" tubing in hot tubs is suction...

This part is a Raindance E2 2 Button Overlay for a 4-1/16" x 1-13/16" Rectangle Topside.          The button configuration of Light/Jet and Temp.   Make sure your old topside does not have a raise area for...

This part is a Raindance E4 3 Button Overlay for a 6-3/8" x 2-1/4" Rectangle Topside.          The button configuration of Jet, Temp and Light left to right.     This Overlay can be used to replace your...