Coast Spa oval digital topside control panel with LCD screen. This listing is for a base 4 button topside without the overlay sticker. The topside measures 10-5/16" x 4-5/8" and has a 7 ft cable with RJ45 Jack. Used with their VS based spa packs. The...

Jet body for the 3" thread-in Rising Dragon Quantum jet series. This body has a 3/4" smooth barb for water and a 3/8" smooth barb for air. It requires a 2-3/16" hole size. Includes the Jet Body and Retaining nut Hole Size 2-3/16" Air Connection...

Heater for the compact Balboa BP100 systems with stationary heater. This 4.0 KW heater has 2" unions that measure 3" inside and a length of 15" flange to flange. Includes heater, sensors and unions w/ gaskets.  Do not confuse this heater with the...

3.0 HP impeller for the Waterway EX2 pumps assemblies. This impeller is normally found on motors with a 10.7-12.0 amp motor and fits between the Face and the Volute of an EX2 Wet End. I would advise replacing the Seal when you replace the Impeller. The...

Overlay sticker only for the Master Spas ST1 "Eyeball" topside control panel used in H2X Fitness Series Swim Spas. The topside that matches this overlay can be found here: Topside Control Panel, Master Spas ST1 Eyeball / Spa Touch Mini, 15'...

Master Spas Eyeball ST1 Topside Control Panel with touch screen display. This topside includes a 15' cable with a 4 prong molex plug and is the primary replacement for part numbers X310341, X310334, and X310220. Sometimes referred as the Diamond or Spa...

CMP Jumbo Massage jet with 7-1/2" diameter face in graphite gray with stainless steel trim. This large jet in conjunction with the jet body can replace the discontinued Waterway Jumbo and Jumbo Storm jets. The jet body for this jet can be found here: Jet...

Topside adapter plate for the ACC Smartouch and Modpack KP2020, KP2010, KP2010DP, KP2020TP and the KP2005 models. This adapter plate will cover a larger hole when installing a new retro-fit control system upgrade. Outside Measurements = 9" x 4" Inside...

Topside adapter plate for the ACC Smartouch and Modpack KP1000, KP1000DP and the KP1005 models. This adapter plate will cover a larger hole when installing a new retro-fit control system upgrade. Outside Measurements = 9" x 4" Inside Measurements = 4.65"...

Diverter stem for the Waterway Top Access 1" diverter valves. This style diverter stem is not as common and is used in Waterway diverter valves that were designated as Single Side Outlet.  Please review the pictures to be sure you have the correct...

Single speed 48 frame spa motor rated at 1.5 HP. This dual voltage single speed motor can run at 115 or 230 volts. The amp rating on this motor is 7.7 amps at 230 volts and 15.4 amps at 115 volts. This thru bolt motor will fit any North American wetend...

Low flow square back style heater assembly for Dimension One (D-1) hot tubs and spas that utilize the M-Class control system. This 1" heater with dual titanium elements wraps around the control box and has 4 wire connections that connect to your circuit...