You are purchasing a Black Mazzei Brand Model 584K Ozone Injector Assembly Complete that is used inline to create suction to pull Ozone Gas from an Ozonator into the Hot Tub water. This Injector can be used in place of the Red Injector 684K. This...

You are buying a Waterway Brand Flapper Tee Air Check Valve with a  1" Slip X 1" Slip Fittings on each end. This valve is used to allow air flow in one direct and to stop water flow in the other direction when plumbed properly in a Hot Tub. The...

This part is a 5.5KW Titanium Heater Complete Assembly includes Tube, Element, Metal Case and connecting wires. This unit features a high limit holding tab and a port for the pressure switchThis Heater Fits Cal Spa Hot Tubs and Is a Perfect replacement...

This part is a Artesian Island Series Overlay for a 8 Button 3 Pump 800D Topside.  The Buttons consist of Time Mode/Prog on the left of the screen and Warm, Cool, Light and Jets 1, 2, and 3 on the right of the screen. This curved top overlay is 8...

This kit is a 2" Slip X Dead End X (4) 3/4" Barbs X (1) 3/4" Barb manifold repair kit for freeze damaged Cal Spa or Coleman Spas. The manifolds are found on the left front side of the tub usually and has 4 lines and the drain attached to...

This part is a 5.5KW Heater Complete Assembly includes Tube, Element, M7 Sensors, Split nuts and Gaskets. This unit features a 5.5Kw Element, Tube with (2) M7 Sensors on either end with (2) Split Nuts and gaskets. I also offer this heater and tube...

We do have these in stock now!! This part is an Old Style 3 Terminal Power Block found on many Balboa Brand Spa Hot Tub Boards. This terminal Block can get burned on one leg if you can solder you can replace this part and not buy a board if this is the...

This item is a CMP Brand LED Single Light Lens that features a 1" wide face and hole size of about 1/2"...      

This part is a Hot Tub 2 3/8" Mini Light Lense Kit with the gasket, Nut, and Light Holder. The face size is 2 3/8" and the hole size is Approx. 1 5/8" to 1 3/4". This fits Artesian Spas and other Brand tubs that have a small light lens. The reason they...

This kit is a Standard 5" Hot Tub Light Lense Kit with the gasket, Nut, Light Holder, 12V Bulb and Amp plug wire. The face size is 5" and the hole size is 3 3/4".This fits most tubs that have a large light lens but be sure to measure the hole there are...

This opart is a Standard 5" Hot Tub Light Lense Kit with the gasket, Nut, Light Holder & 2.8oz of Silicon. The face size is 5" and the hole size is 3 3/4"and it comes with a tube of Special Silicon to seal the lens when installing. This fits...

This kit is a Chrome 5" Hot Tub Light Lense Kit with the gasket, Nut, Light Holder and a 2.8oz of Silicon. The face size is 5" and the hole size is 3 3/4" and this kit comes with a tube of Silicon that is needed to seal the lean when installing. This...