This part is a LA Spa Hot Tub Gray Neck Pillow found on some 2003 and newer LA Spa Hot Tubs.   It is right at 12 " long Edge to Edge, 4 3/8" Wide on the edge top to bottom and it has 1 pins dead in the center in the top rear of the pillow....

This part is a Complete Jet Internal, Ozone Cluster, 2" face diameter, Fixed, White, Requires a 7/8" hole size.. This part is New Old Stock so there will be some minor cosmetic blemishes because of the long term storage of these jets faces..  For...

This part is a Complete Jet Internal, Waterway, Ozone Cluster, 2" face diameter, Fixed, Stainless Steel, White, Requires a 1" hole size.. This part is New Old Stock so there will be some minor cosmetic blemishes because of the long term storage of these...

This part is a Complete Jet Internal, Waterway, Ozone Cluster, 2" face diameter, Fixed, Smooth, White, Requires a 1" hole size.. This part is New Old Stock so there will be some minor cosmetic blemishes because of the long term storage of these jets...

This Wet End is a 2" x 2" 1.5HP 48 or 56 frame Ultimax Vico® that would normally be found an a 230V pump with 9.0 Amps High speed or 14.0 Amps at 115v..  This side discharge, 2" x 2" mbt which would measure about 3" edge to edge on the threads,...

This part is a (1) 1 1/2" Slip X 1" Slip Coupler PVC Plumbing Fitting. The Coupler receives a 1 1/2" fitting which measures 1 7/8" OD on one side and then receives a 1" fitting which measures 1 1/4" OD on the other side...

This is a 1" Slip x Spigot Plug which measures 1 5/16" OD on one end and 1 5/16" ID on the other side it can be used to plug off a 1" Slip port which measures 1 5/16" ID on a manifold or other fittings or Cap a 1" Slip fitting that would measure about 1...

This part is a Temperature and Hi-Limit Sensor that fits some ACC SmartTouch control systems there is one sensor bulb is 1/4" Diameter and it uses (2) 2-pin connectors.. Fits most ACC Smartouch and Epack control systems regardless of year.

This part is a Temp and Hi-Limit sensor set for all ACC Smartouch and Epack control systems regardless of year. Original design (Pictured) was one individual sensor for the temp and another for the hi-limit. New style sensor will have one probe, but two...

This part is a New Style 3-Lug Terminal Block found on many Balboa brand spa and hot tub boards. The original factory blocks were a cream/white color, but the new ones we now have in stock are green. They interchange perfectly and work exactly the same...

In limited supply, get one while you can!! This part is a Balboa Circuit board for an EL2000 Mach 2 system it is a new board and can be found under several different numbers.. The compatible topside would be a MOLEX system plug not a phone plug.. This...

This Seal Kit with bearing is used ONLY in Watkins HotSpring Caldera Wet Ends where the motor has the Vendor code of 3536. This kit features the seal, (1) bearing and an install tool as well as silicone to install the seal with.. It is 1 39/64" Across...