Hot Tub Parts of America

See the Informational videos here first. This kit is a 2" Spigot X Dead End X (6) 3/4" Barbs manifold and (3) 2" Spigot X 2" Slip X (6) 3/4" Barb manifolds and a 2"...

See the Informational videos here first. This kit is a 2" Spigot X Dead End X (6) 3/4" Barbs manifold and (4) 2" Spigot X 2" Slip X (6) 3/4" Barb manifolds and a 2"...

See the Informational videos here first. This kit is a 2" Spigot X Dead End X (6) 3/4" Barbs manifold and (4) 2" Spigot X 2" Slip X (6) 3/4" Barb manifolds and a 2"...

See the Informational videos here first. This kit is a 2" Spigot X Dead End X (6) 3/4" Barbs manifold and (4) 2" Spigot X 2" Slip X (6) 3/4" Barb manifolds and a 2"...

See the Informational videos here first. This kit is a 2" Spigot X Dead End X (6) 3/4" Barbs manifold and (4) 2" Spigot X 2" Slip X (6) 3/4" Barb manifolds and a 2"...

See the Informational videos here first. This Kit is a 2" Spigot X Dead End X (6) 3/4" Barbs + 2" Street x Slip x (2) 3/4" Barb Manifold Basic Replacement Kit. Note: 2"= 2 3/8" in PVC...

This part is a Pressure or Flow Switch for a Hayward HeatPro Pool Heater.. some of the heater model numbers this fits are HP20654T, HP21104TC, HP21404T, HP21124T.. NOte: This pressure switch is not a...

 This part is the slinger found between the impeller and wet end and the shaft going into the pump motor bearing area and is designed to sling water away from the bearing in case of a seal leak...

This part is a Trough Filler Water Nozzle Wall Fitting featuring a 3/8" Barb that is used in a Waters Edge Hot Tub to fill the waterfall spill over..  Note: This Part is Graphite Gray...

This 1" Waterfall Control Plunger and Cap Replacement Kit is found in some 1" Waterfall or Neck Jet Control valves. This kit features the Cap, plunger and stem, The Gasket for the bottom of the...

This Part is a 1HP Impeller that fits an E-Series 48 Frame 1 1/2" Center discharge Wet End which is found in hot tubs some but on Above Ground pool pumps many times. This Impeller fits...

You are purchasing a 1HP Impeller, (1) Standard Bearing and 1000 Seal with Silicon and a Seal Install Tool that fits an Executive 48 Frame Wet End up to 2HP Motor and a 56 Frame Wet...