Wet End Pump Parts

This item is a 1/2" Air Bleeder Plug with Fine threads that can be found on the Newer style of a Sta-Rite Dura-Jet DJ Series Wet ends only.  If you need the O-ring for this plug only Click Here: Sta-Rite Pump, New Style Drain...

This part is a 7 3/8" ID O-Ring only for a 2 1/2" x 2 1/2" WUA500 or SWIM56-15 5 Horse Power 56 Frame Pump Wet End fits Power-Rite Guangdong LX Brand SWIM56-15 Pump Motors only. These pumps usually have the part number Swim56-15 or WUA500 on...

This part is a Wear Ring that only fits LX Vendor Code 3536 Impellers for a 48 or 56 Frame Pump Wet Ends and measures 13/16" thick from front to back... LX Pumps..  

This part is a Front and Back Volute for a Vico, Ultimax, 2" X 2", 48 or 56fr motor.. This part will fit both 48 and 56 frame motors and does not come with any other accessories like the seal, bolts or impeller.. For other parts click this link for this...

This part is a Wear Ring that only fits Guangdong LX or LP Impellers for a 48 or 56 Frame Pump Wet Ends and measures 3/4" thick from front to back... WUA Pumps.. Note: When Replacing some original LX Pump faces the wear ring was built into the face....

This wear ring measures 2 3/8" inside Diameter and fits only 3.0HP Aqua-Flo XP2e and Xp3 Impellers.. If you have 1.5, 2.0, 2.5 or 4.0HP they require a different Wear Ring which measures 2 5/8" Inside Diameter.. Look at the chart in the photo section...

This parts is an Executive 2 1/2" Mpt Threaded Face plate assembly (Which will measure about 3 11/16" Across the Threads) less the O-rings, Screws, Bleeder Plugs and other hardware needed to attach it to the volute..There is another version of the face...

This parts is an Executive 2" Threaded Face plate assembly (Which will measure about 3" Across the Threads) less the O-rings, Screws, Bleeder Plugs and other hardware needed to attach it to the volute..There is another version of the face with a 2 1/2"...