Heater Manifolds

This part is an Adapter, Drain Plug, Sundance / Jacuzzi, 1/4" MPT x 3/8" Ribbed Barb, Stainless Steel, Less O-Ring.. Used on Various J-200, J-300, J-400, J-500, J-LX Series Spa Pump HeadsO-Ring is Required, Teflon Tape Not Used Click here for the...

This item is a Modified 2 1/2" Heater Union Tailpiece with a Pressure Switch Tap and Gasket that is used on may heater tubs that measure about 3" inside diameter of the tube.. It also has a 90 degree 1" Barb fitting.. This Union has had a Pressure Switch...

This part is a Set of (2) 2 1/2" Therm Style Pump or Heater Union Gasket Only for use with a 2 1/2" Heater or Pump Union. If your heater or Pump is 2 1/2" this part could be correct we offer (2) different sizes of 2 1/2" gaskets so you need to...

This part is a 2 1/2" Thread X 1" 90 Degree Barb Heater Union with Gasket that matches Union.   The Union receives a 1" ID pipe on the barb side and then Screws to a 2 1/2'" Heater Flange using a 2 1/2" Nut on the heater side...

This item is a 2 1/2"" Heater Union Tailpiece with a Gasket that is used on may heater tubs that measure about 3" inside diameter of the tube.. It also has a 90 degree 1" Barb fitting.. If you need a gasket for this union click this link.. 2 1/2"...

This part is a 2 1/2" Thread X 1" 90 Degree Barb Heater Union. The Union receives a 1" ID pipe on the barb side and then Screws to a 2 1/2'" Heater Flange using a 2 1/2" Nut on the heater side. This part is used on Heaters that are...

This part is a 2 1/2" Therm Style Pump or Heater Union Gasket Only for use with a 2 1/2" Heater or Pump Union. If your heater or Pump is 2 1/2" this part could be correct we offer (2) different sizes of 2 1/2" gaskets so you need to verify your...