Pressure Switches

This kit is features a 1 Amp Pressure Switch and (2) Blue Spade connectors that can be used in place of the Tradional Square Pressure Switch found on some Hotspring Tubs by Watkins.. This Switch features 1/8th" MPT Standard Threads and 2 Spade...

This part is a Pressure or Flow Switch for a Hayward HeatPro Pool Heater.. some of the heater model numbers this fits are HP20654T, HP21104TC, HP21404T, HP21124T.. NOte: This pressure switch is not a thread in type it is made be mounted through a hole...

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This part is a Electronic Pressure Switch for Watkins Solana, Caldera & Hot Spot, 2006 Thru Current that features 1/8th" MPT Standard Threads and 2 pin connectors for attaching the 2 wire 3 hole connector for a Watkins Hawk board. What goes wrong...

This item is a 1/8" MPT Plastic Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole...

You are buying a Pressure Switch RP2100 with Plastic Header that fits a Raypak Gas Heater System, 105B, 185, 130A, 207A, R185A, 1.75psi..  PRESSURE SWITCH IS A BARKSDALE (THE LITTLE GENERAL) SWITCH # MSPS-EE05-Q71 .5-5.0 PSI (8 MAX) MAX...

This video is about The Spa Guy showing How To diagnose a FLO Code on a Catalina Spa with Balboa Controls.. it is a similar process on other brands as well...    #sparepair #hottubrepair spaguy #thespaguy Save Save Save Save

This video is about The Spa Guy shows you how he diagnosed a bad Pressure Switch for a FLO Code after the tub was powered up...     #sparepair #hottubrepair Save Save Save Save

This item is a 1/8" MPT Brass Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or...

This is a replacement pressure switch for some Gecko systems and more..  Manufacturer Tridelta/Tecmark Switch Type Pressure Pressure Switch Rating 1 to 5 psi PSI Rating 1 to 5 psi Pressure Switch...

This item is a 1/8" MPT Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or the...

This part is a Series 4000 Pressure Switch, 25A, Tecmark, 1/8"mpt, SPDT, Plastic..  The number on your original switch would be 4015P.. Manufacturer Tridelta/Tecmark Switch Type Pressure Pressure Switch Rating 1 to 11 PSI Rating 1 to 11...