PC Control Boards

This part is a Circuit Board Kit, Expander for Balboa VS or EL Systems for the Blower circuit, w/10 Amp Fuse, w/Cables.. Please Note: Circuit boards are a final sale and cannot be returned Circuit Board Control Type Spa Control Circuit Board...

This kit is a (1) Standard Balboa Board Replacement Repair Relay along with (1) Spade to Spade Jumper and (1) Spead to Loop Jumper used to do a beef up Jumper Style repair on Some Balboa VS and EL Boards and others...  When replacing board relays...

This tool can be used to drill out the hole in the boards when changing out relays.. After you desolder a relay you can use these bits to open the holes up then slide the new relay in the holes and solder.. This also helps you to prevent damage to the...

This kit is a Set of (2) Standard Balboa Board Replacement Repair Relays along with (3) Spade to Spade Jumpers used to do a beef up Jumper Style repair on Some Balboa BP Boards and others...  When replacing board relays you may need this drill bit...

This part is a Daughter Board 1 (DB-1) Kit for Waterway NEO 2100 Spa Control System. Used to add an extra 2-Speed pump to the system.Kit Includes: (3) 1/4" Hex #6-32 x 1.5" Standoffs, (3) Screws and (1) Zip Tie. NOTE: WE DO NOT ACCEPT RETURNS ON...

  This part is a 3 Terminal Power Block found on some Jacuzzi or Sundance Control pack and board set ups..   Jacuzzi® Spa Terminal Block, Two Position Strip (TB1, All Models Except The J-380/J-385, J310/J-315 And J-230). Also...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This Item is a Board Fuse .05Amp Slo Blo MDA Style Ceramic Fuse that measures 1 1/8" Long x 1/4" Wide and is used on some Hot Tub or Pool Boards. This is a smaller automotive style fuse that does not have glass but used ceramic to dissipate heat. You...

This part is a Terminal Block 6 Position 40A 115 or 230V.. that fits Balboa Duplex Digital and Super Digital Board System with (6) Tabs to connect the board to the components.. 6 position terminal block 5-3/16" overall length.

This part is for a Set of (2) Standard Balboa Board Replacement Repair Relay made by Zettler. This Relay is the standard relay found on most Balboa Boards but it has double tabs on it so you can add jumpers from the tabs to the feed and load side of the...

This part is a Set of 4" Jumper Wires that would go from a standard heater element Electrode Tab to the board bolts.. These can be used on 4.0kw to 5.5kw elements to transfer voltage from the circuit board to your heater. Uses a 10 gauge wire...