Electronic Control Systems and Parts

Caldera Hi-Limit sensor used on the Advent control systems from 2002 - current. This sensor is found mounted to your heater and detects high heat conditions to protect the heater from running dry or flow restrictions.  Found in Caldera, Utopia,...

OEM Caldera temperature sensor with 3/8" bulb. This sensor is normally found mounted into a sensor well and makes direct contact with the spa water. On the other end it plugs into the circuit board via the 4 pin, 2 wire JST plug. Found in Caldera,...

AMP cable splitter for use with Gecko or Balboa spa packs. This 14/3 splitter is commonly used for the circulation pump and the ozonator to share one receptacle on the main circuit board. It has a 6" length with one male AMP plug and 2 female AMP...

Sundance and Jacuzzi Flow Switch for 2006-2009 models. Jacuzzi used this switch on all 400 Series models 2006-2009 and in various Sundance models, including in ground units. Includes the tee with mounted flow switch, 5 ft cable and box end connectors...

Balboa "Y" Splitter used to add an additional Pump # 4 on BP spa packs and control systems such as the BP7 and BP2000. To utilize this splitter you plug the male end into the Pump 2 port, go into the programming and set pump 2 as a 2 speed circuit, then...

This part is a 72" AMP Style 3 Wire Cord With Male Plug that is used on a 1 speed pump or blower.. Note: To use this cable with a blower you will cut the spade connector off the end off the end and attach with crimp connectors.  The Wire colors are...

This part is a 60" AMP Style 3 Wire Cord With Male Plug that is used on a 1 speed pump or blower.. Note: To use this cable with a blower you will cut the spade connector off the end off the end and attach with crimp connectors.  The Wire colors are...

This part is a Amp Cord, Pump 1, 2-Speed, 4-Pin Amp, 14/4, 96" Long, Plug Attached, w/Terminated Ends. The Wire colors are as follow on most systems: Red=High Speed Black=Low Speed White=Neutral or Common Green=Ground There are exceptions to these...

HydroQuip Temperature Sensor, 72" with 1/4" diameter temp probe. Common to find these used on the Versi Heaters and 9700 series spa controls. For SSPA, USPA, MP, 6200, 9200, 6500, 7500, 8500, 9500, 9700, 6330, 9330 series of spa packs and controls by...

This part is a Cable and Plug for an In.Link on system on IN.XE and IN.XM systems Aeware Gecko. The cable is for Pump 1, 2-Speed, 15A, 230V, 8' Cord. Cord Type Cord Appliance Pump, 2-spd Pump Cord Length 8ft, 96" Male End Plug Style in...

You are purchasing a Fuse Holder Assembly, SC-25 or SC-30, Panel Mount..  This fuse holder requires a fuse sold here: Fuse SC-25 SC25 25 Amp Buss Bussman Littlefuse SLC25 1 X Spa Hot Tub Fuse SC-30 SC30 30 Amp Buss Littlefuse SLC30 Balboa Gecko...

This part is a complete New Old Stock Heater that was used on some Icon or Jumpking Hot Tub and Others.. Stainless steel, 1-1/2" x 8-1/2", 1.0kW/115v replacement heater with ground lug, (2) 1-32 x 3/8" mounting studs, and split nuts. The element is...