Electronic Control Systems and Parts

Gecko has discontinued this heater strap and we now send the new version here: Jumper Wire, Heater Element, 10 gauge x 4", Board to Heater Gecko 3" heater strap used on some M-Class spa packs to connect the heater terminals to the circuit board...

This part is a Sensor, Hi Limit, HydroQuip, 18", 1/4"diameter, 2-pin, After 5/03, 6200, 6220, 6230, 6330, 7500, 9700 series control systems..   Sensor Application Spa Control Sensor Type Hi...

Mini Size Pump Plug 2 Speed48" long, 14/4 AWG

This part is an Enclosed Circuit Board Relay for 15v DC boards like you would find on Jacuzzi, Sundance or others.. Coil contacts are on bottom of relay at PC board. Trace saver tabs are available at top of relay Coil Voltage...

This Temperature Sensor Set has 1/4" probe widths on both probes.. This set usually found on tubs with no heater that uses a firestick or heat jacket to heat not a real heater... I have seen these on Dreammaker and other brands... The temp probe is...

This part is a Vacuum Switch like you will find on some  Cal Spas in the suction side of the pump. Specs V4001P-DX Replacement, 21A, 1/8"mpt. For a switch like the original click this link: PresAirTrol Style Vacuum Switch This is a normally open...

This part is the Cord Side Male AMP Connector that houses (3) Male Pins.. The Pins are not included..   Terminal Type AMP Terminal Style AMP Plug Housing Male Number of Connections 3 Terminal Amperage 20A The other...

This Part is a Surface Mount Style HI LIMIT: Single Pole Single Throw THERMAL FUSE Auto Reset (With NO CAPILLARY)This Hi Limit Surface mount surface mounts to the heater in a spot where it can read what the actual water temperature is flowing through the...

This part is an Amp Style Female Pin crimp connector that fits wire that is 14-20 Gage and is usually found on the pack or board side plug connector that is mounted on the board housing.. This listing is 25 Pins..   Terminal...

This item is a 1/8" MPT Brass Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or...