This Kit consists of 4" of 3/4" Inside Diameter Clear Tubing, (2) Clamps. (2) 1" Street x 3/4" Barb Couplers and (2) 1" Couplers.. This Kit is used to connect your 1" pipe connection that is being replaced to a more modern outside barb type seal... You...

This part is a 90 degree slide on glue in style 1" slip adapter fitting. This fitting slides onto a 1" air control valve before you glue any plumbing to the bottom of the valve and then it gives you a 1" slip fitting on the side in a 90 degree fashion....

This part is a Clear Smooth 3 3/4" Spa Diverter Cap only. This is a NON  Buttress Cap if your cap has the word Buttress stamped in it look in our store for a Buttress cap. This Diverter Cap mounts on top of the Diverter Valve with the...

This Part is a Barbed Bleeder Barb with O-Ring that fits New Style 48 or 56 Frame WUA Intertek LX Brand Pump Wet End that uses a fine thread bleeder plug.. Watch the video for instruction on how to install this part and also how to...

This part is a Terminal Block 6 Position 40A 115 or 230V.. that fits Balboa Duplex Digital and Super Digital Board System with (6) Tabs to connect the board to the components.. 6 position terminal block 5-3/16" overall length.

This part is a Hydro Quip Silver B Series Flo Thru Heater this 2-1/4" x 15", 5.5kw, used in the Remote Slide Versi Heat Type heater.. This heater does not come with the box and other related parts you would transfer them form your original heater..

This Kit is a Barb Adapter 3/4" Renu Extension Kit that features (2) Clamps, 4" 3/4" ID Tubing and (1) 3/4" Barb to 3/4" Slip /1" Street Fitting that will glue between a 3/4" barb used to add another 3/4" water outlet to a 1/2', 3/4" or 1" piece of...

This part is aTop Draw Style Air Control with a Smooth White Top that measures about 2" wide it requires a 1 1/8" wide hole in the tub to be mounted and accepts a 1/2" slip pipe or fitting in the bottom.   There is a similar version of this...

This part is an Air Injector Jet Body 3/8" Barb Accepts 3/4" Thread in Injector Part with 1 1/4" Face. This Part is installed by adding clear silicon to the flange and screwing the flange into the jet body using an allen wrench. . This Air Jet...

This part is a Electronic Pressure Switch for Watkins Solana, Caldera & Hot Spot, 2006 Thru Current that features 1/8th" MPT Standard Threads and 2 pin connectors for attaching the 2 wire 3 hole connector for a Watkins Hawk board. What goes wrong...

This part is a Complete CMHP 1/15th HP Aqua-Flo 1 1/2" x 1 1/2" (Which measures about 2 3/8" Across the Threads) Side discharge 48 frame wet end for CMHP pumps. This wet end is used with a 48 frame motor that would have about .6 Amps on High Speed on a...

See the Informational videos here first. This kit is a 2" X 2" Slip X Dead End X (4) 3/4" Barbs + 2" Street x Slip x (6) 3/4" Barb Manifold Deluxe Replacement Kit. The Kit consists of (2) Manifolds total one with (6) 3/4" Barbs and...