This part is a Complete Jet Internal, Waterway, Ozone Cluster, 2" face diameter, Fixed, Smooth, White, Requires a 1" hole size.. This part is New Old Stock so there will be some minor cosmetic blemishes because of the long term storage of these jets...

This Wet End is a 2" x 2" 1.5HP 48 or 56 frame Ultimax Vico® that would normally be found an a 230V pump with 9.0 Amps High speed or 14.0 Amps at 115v..  This side discharge, 2" x 2" mbt which would measure about 3" edge to edge on the threads,...

This part is a (1) 1 1/2" Slip X 1" Slip Coupler PVC Plumbing Fitting. The Coupler receives a 1 1/2" fitting which measures 1 7/8" OD on one side and then receives a 1" fitting which measures 1 1/4" OD on the other side...

This is a 1" Slip x Spigot Plug which measures 1 5/16" OD on one end and 1 5/16" ID on the other side it can be used to plug off a 1" Slip port which measures 1 5/16" ID on a manifold or other fittings or Cap a 1" Slip fitting that would measure about 1...

This part is a Temperature and Hi-Limit Sensor that fits some ACC SmartTouch control systems there is one sensor bulb is 1/4" Diameter and it uses (2) 2-pin connectors.. Fits most ACC Smartouch and Epack control systems regardless of year.

This part is a Temp and Hi-Limit sensor set for all ACC Smartouch and Epack control systems regardless of year. Original design (Pictured) was one individual sensor for the temp and another for the hi-limit. New style sensor will have one probe, but two...

In limited supply, get one while you can!! This part is a Balboa Circuit board for an EL2000 Mach 2 system it is a new board and can be found under several different numbers.. The compatible topside would be a MOLEX system plug not a phone plug.. This...

This Seal Kit with bearing is used ONLY in Watkins HotSpring Caldera Wet Ends where the motor has the Vendor code of 3536. This kit features the seal, (1) bearing and an install tool as well as silicone to install the seal with.. It is 1 39/64" Across...

This Seal Kit is used ONLY in Watkins Hot Spring Caldera Wet Ends where the motor has the Vendor code of 3536. This kit features the seal and an install tool as well as silicone to install the seal with.. It is 1 39/64" Across the back of the Spring...

This Seal Set is used ONLY in Watkins HotSpring Caldera Wet Ends where the motor has the Vendor code of 3536. It is 1 39/64" Across the back of the Spring Seal part that goes into the volute or wetend back and the Ceramic & Rubber part that goes...

This Kit Fits Watkins, Vendor #4081, Wavemaster Pumps found under the name Wavemaster. This Kit Features (2) Bearings, (1) Seal and (1) 1/2oz Tube of The Professor's Silly Juice a Specially Formulated for Hot Tubs Silicon Sealer.   Note: Watkins...

This is a Set of (3) barb plugs used to plug off a 3/8" port on Air manifolds or Air Sides of Jet Bodies that are above the water line of the tub. We offer many different plugs based on the brand of manifold.