This part is a 45 Degree 2" Street X 2"Slip PVC Plumbing Fitting that has a Threaded hole for a Pressure Switch. The Union glues into a 2" fitting on one side and then receives the fitting on the other side. It will Glue into any 2" fitting to make a...

This Connect Kit is an Air Bleeder barbed plug, 3/8" X 3/8" Barbed Coupler, 4" of 3/8" Tubing and Silicon sealer usually used on a Waterway Hot Tub Pump Face to bleed the air off the pump while filling the tub up. I have seen these fittings in many...

This Part is a Wet End O-Ring for a 48 or 56 Frame Face Plate for a Jacuzzi Premium or Sundance WUA400 6500 Intertek LX Brand Pump Wet End only.. Watch the video for instruction on how to install this part and also how to determine if this...

This Parts is a NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this O-Ring until you...

This item is a 48 Frame Vico Wet End with 2" x 2" inlet and outlet that would measure about 3" across the threads and it has a 3.0HP impeller which would fit a motor that has 10.0-12.0 amps at 230V and there are no 115V motors this fits.. Pump to Motor...

This part is a Tee that is 2"Slip x 2" Slip x 3/4" FPT.. This part is usually found in plumbing with spigot screwed into it.. Note there are 2 Spigot sizes 3/4" and 1/2" Threaded..   If you need a spigot that threads into this tee click this...

This part is a Sta-Rite Dura-Jet Complete 2" X 2" Wet End that fits both 48 or 56 frame motors and would fit a 230V Pump that is 8.0 Amps or a 115V pump that is 12.0 Amps.. The 2" fitting actually measures about 3" Edge to Edge across the threads.. It...

This pump is a Complete 3.0HP Hi-Flo Side Discharge 48-Frame Pump is 2" x 2" which measures about 3" across the threads and is an efficient pump designed for high volume discharge for faster filtering cycles. Sometimes marked as 4.5 SPL which is the...

This part is a Balboa Circuit board for an EL2000 Mach 3 system it is a new board and can be found under several different numbers.. The compatible topside would be a MOLEX system plug not a phone plug..THIS BOARD INSTALLS IN A PLASTIC BOX and Will not...

This part is a 4 Button, VL401 LCD Topside, E4, Balboa, Lite Duplex Digital, (1) Pump (1) Blower, Temp, Light... This topside control is made for use on Balboa VS500Z, VS501Z systems. It will also work on Hydro-Quip Platinum Series 6501B and 6502B...

This part is a 4 Button, ECO401 LCD Topside, E4, Balboa, Lite Duplex Digital, (1) Pump (1) Blower, Temp, Light... This Topside is used with Valve, SUV, VS500, VS501 and more systems.. The required hole size is about 2 1/4"x 6 3/8"....

Balboa Water GroupStainless steel replacement heater assembly, 5.5kW/230v, 2" x 15". Includes a pressure switch, Hi Limit Sensor on the right side. Made for Balboa Value and Balboa LE control systems. Housing Configuration  ...