Applied Computer ControlsStainless steel flo-thru replacement heater assembly. Measures 12-1/2" x 2" and has (2) mounting studs, pressure switch tap at 0 degrees from the heater terminals, external thermowell and a 5.5kW element. Commonly found on the...

This pump is a Aqua-Flo 1019801 48frame 230V 2 Speed with a 2" x 2" Wet End  that measures about 3" across the threads.. The amperage is 8.5 Amps on high speed and 2.8 Amps on low speed and this pump will work as a one or speed pump..   If you...

This 2.0HP Horse Power 10.0/3.5 Amp (2) Speed 56 Frame Complete Pump is a LX Pump Vendor Code 3536 Intertek LX Brand Pump. These pumps usually have the part number 1019801-03 on the label. It is about 7 1/4"" across the face of the pump, it measures...

This part is a (1) 90 Ell 1 1/2" Street X 1 1/2"Slip with an 3/8" FPT hole in the side.. The 90 ELL receives a 1 1/2" fitting on one side which would measure 1 7/8" OD and then slips into a 1 1/2" fitting on the other side that would measure 1 7/8" ID on...

This is a Kit that features (1) PS-200 Seal and (2) Bearings that fit most motors that are mated to Aqua-Flo Pump Wet Ends as well as Waterway " Viper" Wet Ends, The Professor silly Juice to seal the seal. This Seal is used in Most Aqua-Flo Wet Ends...

This part is a Bypass Valve Flap made by Waterway found inside of In-Line, Top Load, Top Mount, Front Access, 2" Filter Housings... You will find these in several colors and they will have the numbers 602-5101 or 601-5111 on the valve in most cases....

This Part is a Fine Thread Bleeder Plug for a 48 or 56 Frame Vendor Code 3536 LX Pump Wet End.

This part is a Wear Ring that only fits LX Vendor Code 3536 Impellers for a 48 or 56 Frame Pump Wet Ends and measures 13/16" thick from front to back... LX Pumps..  

This Part is a Wet End O-Ring for a 48 or 56 Frame Face Plate for a Vendor Code 3536 Intertek Brand Pump Wet End only.. It is about 6 3/8"" Inside Diameter and about 1/8" Thick..      ...

You are buying a 2 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be...

This pump is a replacement for the Sundance TheraMax II 6500-901 56 frame 2.5HP (1) Speed 230V Side Discharge wet end with a 2" suction side and 2" pressure side which measures about 3" edge to edge. The amperage is 12 Amps on High Speed making it a 2...

This Pump is a Perfect Replacement for a LX 0982601-03 2.5HP 11.0/3.5 Amp (2) Speed 56 Frame Complete Pump. It is about 7 1/4"" across the face of the pump, it measures about 7 3/8" from the bottom to the top of the pressure side of the volute, it...