This Seal is a PS-100 that fits a Starite Max-E Glas or Dura-Glas Swimming Pool Style Pump. This Seal is rarely found on Hot Tubs. Shaft Seal Head Type A Model PS-100 Quality/Material Good - Buna Graphitic Plastic Shaft Size 5/8" Seal Outside Diameter...

This part is a (1) 1 1/2" Slip X 1 1/2"Slip Coupler PVC Plumbing Fitting.   The Coupler receives a 1 1/2" fitting which measures 1 7/8" OD on one side and then receives a 1 1/2" fitting which measures 1 7/8" OD on the other side...

Inside Pipe Repair Glues Inside 2" Pipe and allows a 2" Slip to be glued over or a 1 1/2" Slip to be glued inside. Magic Mend Simply cut the bad fitting off of 2" hard pipe and remove it from the system. Glue the 2" Spigot Street end of the Magicmend...

Barb Adapter 3/4" Barb x 1/2" Spigot , The Glue Side glues inside a 1/2" Fitting which would measure 3/4" and a 3/4" ID tube would be glued over the barb.

This Part is a Waterway Old Style Jet internal that has no face flange trim. It simply screws into the jet body Right Hand Thread using the 4 tabs behind the nozzle. Usually the jet body flange is covered by a Chrome Ring to cover the jet body flange...

This part is a Replacement Diffuser for a 5"- 5 1/2" Wide Faced Storm Jet made by Waterway. Watch the below videos for more information on this type diffuser and installation instructions as well.. These jet diffusers are removed by pulling the Jet...

This Kit is an 4HP Impeller for an Executive 48 Frame Wet End up to 4HP Motor and a 56 Frame Wet End 4HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

Inside Pipe Repair Glues Inside 1 1/2" Pipe on both ends. Magic Mend Simply cut the bad fitting off of 1 1/2" hard pipe and remove it from the system. Glue the 1 1/2" size Magic Mend in between two pieces of 1 1/2" ID pipe to mend pipe back together PVC...

This is a bottom mount pressure guage with a 1/4" MPT Threaded Mount used on Swimming Pool and Inground Style Hot Tub Sand and DE Style Filters.

This is a plug used to plug off a 3/4" port on Waterway Shur-Grip manifolds only.. An example of use would be making a (6) port manifold a 5 by plugging one.

This part is a 35 Square Foot Filter Cartridge that is 4-15/16" Outside Diameter x 9-1/4" in Length. It has a hole in the top and the bottom that are 2 1/8". This Filter (The Most Popular) is found many Spa Hot Tub Brands Aber , After Hours , Belize ,...

Len Gordon has discontinued this switch. We now send this pressure switch in its place: Pressure Switch, 25A, Tecmark, 1/8"mpt, SPDT, Plastic This part is a 25Amp Pressure Switch that features 1/8th" MPT Standard Threads and 2 Spade connectors...