This Kit is an Marquis Spa Hot Tub Gray, O-Ring Kit fits 4" Diverter Cap with 3" Style Thread.  This Diverter handle Slides on the Diverter Valve Stem is used to operate the Diverter Valve. The Cap screws down onto the existing diverter...

This part is a Housing Mount Kit for Skimmer Weir Door some Dynasty or Waterway Filter.. The kit features (2) Mounts and (4) Screws.    This Part is used in Dynasty and Bahama Spa Hot Tubs to hold the weir door in place and Many Others...

This part is a 5" Black Round with Starfish Shaped Cuts Diverter Knob with no Center logo. The Square under the cap that fits on the stem measures 7/16" inside.. This knob has 602-3880 cast in the underside.. This Diverter Knob Handle Slides on the...

This part is a Motor only , Century, 3.0hp, 230v, 2-spd, SF 1.00, 48Y frame, 12.0A.. Motor Amperage    12.0AVoltage    230vPhase    1 Phase (1ph)Frame Type    48YSpeed    1 Speed...

This kit is a Gray Waterfall Valve Connect Kit with 90 and Straight to Connect to Ringlet Style Hose.  You will need glue and you can find it here: PVC Leak Loc Low Voc Hot Blue Glue 4oz for Hot Tub Spa PCV Plumbing Repair   This kit...

This side discharge DJ pump is a Rare Balboa / Pentair / Sta-Rite Dura-Jet 2'X 2" Side Discharge 48Fr 230V 2.0HP Pump Complete. Also known as the Cascades or DJ spa and hot tub pump assembly made by Balboa Water Group. This side discharge pump assembly...

This part is a Complete Jet Internal, CMP, Typhoon 400, 4" face diameter, Directional, Wave Style, Stainless Steel, Gray...   NOTE: Cmp Jets do not offer a Replacement Diffuser for this Jet..   Installation Type Snap In Face...

You are buying a 1.5 HP 48 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be...

This part is a Hydro Air 1/2" Top Draw Air Control Stem Assembly only.. It measures about 1 11/16" Across the top and the threaded hole this would screw in would be about 3/4" Wide.. the shaft from the bottom of the lid would be about 1 3/4".. See...

This part is a Jet Internal, Waterway Power Storm, Thread-In style. 5 Scalloped and Gray, 5" face, with Single Roto style internal and Adjustable on/off control.

This part is a Jet Internal, Waterway Power Storm, Thread-In style. 5 Scalloped and Gray, 5" face, with Straight style internal and Adjustable on/off control.

This part is a Jet Internal, Waterway Power Storm, Thread-In style. Stainless Steel and Gray, 5" Smooth face, with Twin Roto style internal and Adjustable on/off control.